Can anyone tell me the speaker size for my 2001 ford ranger edge. I
want to buy new ones and am woundering size they are in the doors and
the third doors. Thanks

What causes my 351 to idle up and down up and down? not extreme, just
a flucuating idle.
Any ideas?  Thanks

My truck generates static on the radio when the Temp Control is set to Full
Cold or Full Hot. If I move the temp control off of either limit, the static
goes away. I get the same static when the headlamps are switched on.
Is there a TSB out there on radio noise that comes from the ...

I get static on the AM radio ONLY when the Temp Control is set to full Min
or full Max, or when the headlamps are on. If I set the temp control off of
the physical limits of the dial, or set the headlamps off (this is a bit
disconcerting to my passengers and some of the oncoming ...

I've got a 1970 3/4 ton Ford that I'm thinking of selling. I've had it
for 15 or more years, but I have no ideaof what to price it at. All
the online sources, like kelley blue book only seem to go to around
'88. I'm looking for a source that can give me an idea what this guy's

I need to replace the cab window gasket for the topper on my f-150.
not the gasket that goes around the bottom, but the big one that
surrounds the rear cab window. topper is a fliteway and I have not
been able to find any info online about them.

I have a 1991 f-150 5 speed manual that I think the transfer case
might be stuck in 4WD.It squeals and whistles as I drive it and stops
when I engage the clutch.I recently took out the automatic hubs and
lubed them and reinstalled.any help would be greatly

I have a 2006 F-250 4X4 Crew Cab Diesel. All of the air controls for
heating, cooling , defrost and air conditioning work fine, except the
air only flows out of the defroster vents. The circulation does not
change to the floor vents for heating or the dash vents for A/C. Is

I'm trying to replace a bad u-joint in a motor home build on a Ford
E0350 Superduty chassis.  It has the star/spline type bolts holding
the driveshaft to the differential.  Picked up a a set of metric and a
set of SAE sockets figuring one would fit.  None do.  It's around 1/2