Any one have a wiring diagram for a late model crown vic who could
tell me what the wire colors are in the truck for the brake lights and
backup lights?
--

My wife left me a note on the breakfast table...... I quote.... " I WANT A
MUSTANG"
Jake

My wife's 1994 Taurus LX with a 3.8 fuel injected V6 has been dieing on
her. It just dies while going down the highway. It will start right up
right away after it dies. I have driven it on the weekends with no
problems.

All,
I have a 1993 Thunderbird (3.8L) with the automatic shoulder belts. While
the car was running today, I got out of it and the shoulder belt moved about
halfway forward and stopped. When I got back in, it moved about 2 inches to

In my Explorer 2000 that has a 4.0L SOHC engine, the idle RPMs are about 550
while they are supposed to be 800, at these low RPMs the idle is rough. there is
no other problem, does not stall, shifts normally, has adequate power, yields
about 17mpg on highway. I have checked several ...

i just replaced the intake gasket on the 3.0, and 3 of the injectors
were physically broken, too. anyway, well, replaced it, idled it for
about 30 minutes, car idled fine, no overheating no leaking ...
then later took it out on the road and coolant spewing out on the left

Hello Group, I have a '91 mustang convertible... Long story short: a piece of the metal top
structure is broken (can't be repaired) must be replaced...
I have to get this thing fixed ASAP, I live in FL and rainy season is going to start up in a
month or so... luckily it's only ...

I've searched the paper, internet, and ebay...
It seems hard to find a van (unlike trucks).  Can someone provide me
with other options for finding a good van at a reasonable price.
The only good deals I found where on high mileage vans...the dealers

My son's 87 Grand Marquis had an Alternator light on solid.  He replaced the
alternator twice without affecting the problem.  Alternator checks out OK on
the bench.  I verified that the system is not charging and checked for
obvious problems:  loose connections, continuity from the ...

Is there a proper way to remove rust from all areas possible
underneath an older vehicle so I can spray Zero Rust, which is
just a rust proof paint. Yesterday I purchased a 3" rough wire
brush for my 5" grinder and rough tested it last night on metal,

My car is Ford fiesta c 1000ccm 1990"
I need Ford Fiesta: Service and Repair Manual or some documentation for this
car.Do anybody know where can i download that or if someone have it can send
me.I must learn to do some things so please help if you can!

I have a 2001 Taurus, and I'm a volunteer with a number of different
public safety agencies. So I have fire gear and a few two-way radios
in the car.  Now about 8 months ago, people in the back seat noticed
that the shocks seemed loose - i.e. you go over a small bump and it

So I had some stuff done today, been wanting to get the PS fluid replaced so
I had them do it, lady told me $80! Is this normal? She says its because
they use some special machine, Im thinking about $8 worth of ATF and 30
minutes of labor.

I have a 1995 Escort LX wagon and one of the four tubes from the "vacuum
valve" on the top of the intake manifold came off. My hood was changed and I
have no VECI diagram.
I had to go to the garage for another job and asked them to put that tube

I wanted to know your opinion on - if it is a good idea to buy Ford's ESP
warranty. I own a 2001 Taurus wagon and have some minor factory warranty
work done which include:
- replacement both outer CV boots