I have some problems by changing gears.
Also when the car is stopped, I can hardly change gears.
Who can help?
Thanks

I've purchased a 96 Explorer with 128000KM and have been experiencing a problem since the drive home that first day.  When the vehicle is warm (driven for 15 - 20 minutes), I can't seem to pull away from a stop without the engine bucking, almost stalling.  As this is happening, ...

somewhat of a mechanice here -- have haynes -- never removed half
shaft but have to do drivers side -- my question -- whats keeping the
half shaft atttached to the transaxle - is it a pressure fit by
circlip -- any tricks anyone no about -- i ve taken them off to

Help, I have a 96 taurus with a factory am/fm cass. When I put the car in
gear (rev, drive) the radio cuts out. Sometimes it will come back on,
sometimes it won't. Also sometimes the power steering will become difficult,
when the radio comes back on, everything is fine again. This ...

FAST MONEY MESSAGE ! !
FIRST OF ALL, THIS IS NO SCAM. I'M SURE MANY OF YOU HAVE HEARD HOW THOSE
ONLINE BUSINESSES ARE NOTHING BUT A BUNCH OF SCAMS AND RIP-OFFS. WELL, NOT
THIS ONE. I DON'T CARE WHAT YOU'VE HEARD BEFORE. THIS IS NO SCAM AND THIS IS

Here's the deal, I have had problems with the powersteering on this car in
that it leaks fluid. When I parked it last time I could really hear the
powersteering pump struggling. Then when I went out to start it next time
the starter just "clicked" once and that was it. Now it won't ...

Just got a "new" 1989 F-150.  It's got a manual transmission, and
tilt-wheel steering.  The ignition switch needs lots of jiggling to
start the truck, especially when the steering wheel is in a high
position.  I'd like to look at the switch, clean it and/or replace it.

This afternoon driving on the highway my engine coolant temp gauge started
beeping at me. First time I ever seen the temp in the hi range.   I
immediately pulled over and popped the hood to check coolant levels.  All
were fine!  Looked for leaks, nope. Looked at fan to make sure it ...

Hi i have a 67 coupe 289 auto, and  i  think  my tranny is f .u'd ,    i
just rebuilt the entire motor and want to start it  without the tranny
installed , what is the best way to do this   .im  thinking  mount the
bellhousing and starter only.  Any tips or tricks you know of?

I've got a 1986 bronco with a 2.9 engine, I'd like to convert from a
fuel injection system to a Carburetor. Anybody have any advice?
Like what parts I need for this, Manifold - Carb and such.
I've searched the web and found nothing of use.

Does anyone have either a haynes manual, handbook or some other specifications
for this model 1990 ford fiesta bonus
Links to documents would be fine also
Thanks

Is there a tool that makes taking off the center caps easier. There are a
couple of slots on the center cap that you can use to pry them off. Problem
is that it also makes it easy to scratch up the rim. A lot of the Ford
center caps have the same slots so it seems like there should ...

The car:
1995 Ford Escort LX station wagon. 1.9L four cylinder engine,
automagic transmission.
The problem:

I know this is a Ford newsgroup, but I figure the 1981 Mercury Capri used
the same transmission as the 1981 Ford Mustang.  I have a question.  What
manual transmissions came with the 2.3L in the above car?  I have access to
one that I would like to fit in my 1965 Mustang (currently ...

At 60 mph you get a very high pitched noise from inside the car. Sounds like
it is coming from everywhere but I think is from the dash. After you get
above 65mph it goes away.
Any help would be appreciated.