Ford - all Ford cars

Thread preview

Thread	Last Post	Replies

warman praises himself	07 Mar 2005 22:51 GMT	2
>hurc.... if you CAN go to the Canadian PTS website (sorry folks, it's a Ford >only thing), you'll see my name on the Senior Honour Roll..... proof enough >for you. However, I have no way of knowing if you can even access PTS, let
not a master teck lmfao	07 Mar 2005 22:50 GMT	2
hey warman how come after 40 years u are still not a master teck lmfao it only took me 3 years
How high is too high?	07 Mar 2005 16:29 GMT	13
If I am going to lift the front-end of my 93 Mustang GT by placing a floor jack under one of the lower A arms, how high (i.e., by measuring the distance from the ground to the bottom of the tire) can I lift the vehicle without causing any damage? (My intention is then to use the ...
OBD II software	07 Mar 2005 13:40 GMT	6
Does anyone have any experience with steups to connect a laptop to the diagnostic port? What hardware / software combos work well? Which ones don't? I'd like to have something more than just a flashing light to give me the code. This will be for an '02 Town Car.
warman fails diesel lmfao	07 Mar 2005 04:01 GMT	3
On Sat, 05 Mar 2005 02:18:26 GMT, "Jim Warman" <mechanic@tenalpsulet.net> wrote: >You're the expert..... if you can't fix this concern, don't waste your >customers time.
Car Information	07 Mar 2005 03:22 GMT	3
If anyone needs any Info from a step by step repair procedure, A keyless entry programming procedure or a wiring diagram check out www.NeedCarInfo.com
lets see if warman knows diesel	07 Mar 2005 02:19 GMT	12
hey warman u claim to be #diesel dude lets see i have an old 7.3
1998 Crown Victoria turn signal/flasher	06 Mar 2005 20:50 GMT	3
Push the flasher switch, nothing happens. Thereafter, the previously fine turn signals are dead. Took it to Firestone, they said they couldn't figure it out, but on the way home the turn signals were working fine. Short of never trying to turn the flashers on again, which is a ...
econoline 150	06 Mar 2005 20:16 GMT	6
I have a '97 e150 conversion van. "Sometimes" the van vibrates on acceleration. I assumed it was the tranny , but aamco checked it out and said the tranny is fine but did not know the cause of vibration. The best way I know how to describe it is --I get the same type of sound ...
1994 Crown Vic P-71 Police Car ?'s	06 Mar 2005 16:20 GMT	11
Greetings All: I just purchased a 1994 P71 with only 160,200 miles on it. Since I bought it from the local police it did not come with an owners manual or any paperwork. Can someone point me in the right direction to get
Removal of left top door hinge 1994 Explorer?	06 Mar 2005 16:07 GMT	1
I am posting this for my brother Al in Vancouver. Any ideas? Bill, I've been trying to replace the left top front door hinge on Mary's Explorer but can't figure out how to get it off. One of the bolts has
whose the a.shole here	06 Mar 2005 09:10 GMT	4
On Fri, 04 Mar 2005 22:37:23 -0500, nospam.clare.nce@sny.der.on.ca wrote: >On Fri, 04 Mar 2005 12:39:41 GMT, fordly863@hotmail.com wrote:
Chugging 1995 Aerostar	06 Mar 2005 04:33 GMT	9
Well, I was given my father?s old ride, a 1995 Ford Aerostar that?s in pretty good shape with about 127k miles on it, 4 Wheel Drive, and the 3.5L engine. Today, as I was driving home from school (which is a good 8 or 10
taurus flex pipe	05 Mar 2005 17:34 GMT	2
Will a 99 flex pipe fit on a 95 Taurus if I cut the fancy end off? thanks, Joe
3.0 litre v6	05 Mar 2005 15:52 GMT	3
Hi everyone, first time on here. Looking for a engine. A 3.0 litre v6 fuel injected for a 1993 Ford Ranger 5 speed standard. I will consider a running motor or I may consider parts such as an intake and/or other parts as I may be able to put the one I have back together. ...