I started driving my F150 today and it is fine in first gear, but when
it shifts and it is not floored it is very sluggish - almost like it
wants to stall.  It was so bad when I was trying to see what was going
on that the check engine light came on.

Any suggestions on what could be bad.
My Contour shut off while driving down the road.  Had it towed home.  It
started  2 or 3 times after that and now it won't start at all. It acts
like it wants to start but won't and you can hear the fuel pump kicking on

1997 F-150, 4.2L, 120,000+. After truck warms up, idle still seems high and
truck runs rough at all speeds and idle. Feels rough during acceleration.
Sometimes when shifting from 1st to 2nd and from 2nd to 3rd, engine surges
for 2-3 seconds after backing off accelerator. When ...

Howdy, folks;
I could really use some advice with a problem that has appeared in a
2000 Ford Windstar that I bought used back in Jan. 2004 with about
55,000 miles on it at that time. It has the 3.8 liter V6 engine.

I have 1987 Coachamn Class C RV which is on a Ford E350 chasis. I have
a problem with A/C system.
O rings are leaking in the quick-connect. I got the tool to seperate
the quick-connect. When I push the tool in, I can hear the spring snap

I put front disc brakes on and left the drums on back, replaced master
cyclinder and bled system and the brake pedal still goes to the floor!  
Need help,, don't understand how to use the proportioning valve that we
got with the brakes....the directions says can't put between the ...

I know this is not a dodge group but there are good peeps here so i
thought i would ask.
anyone with experience on ac systems in a 96 neon?
both cooling fans come on when ac is switched on so thats ok

I have a ford 1999 taurus, and my daytime running are not working. I have a
replacement relay for it but do not no were it is located. I ask my ford
dealer and they said I would have to bring it in. All i need to know is
were it is so I can chande it out. Can someone help me ?

I have found an F-250 I want to buy, but it has the snow plow
option(heavy duty front springs)....i was told it will make for a very
stiff ride...anyone have any experience with this? Thanks.

I have had problems with all the door lock motors on this car with
110,000 miles.  I've been able to replace them myself but this time the
RIGHT FRONT door cannot be opened from inside the car or from the
outside using the pull handles. The key will not turn clockwise to the

anyone out there able to tell me how to replace a clutch/starter switch
on an 88 ranger? I'm having trouble removing the old one from the clutch
pedal. i've cut the 2 plastic ties, unhooked the pin and disconnected
the electrical connector but something is keeping it from ...

I can't figure out what is killing my battery and need help.  Please give
me some idea as to what may be draining my battery and how to fix it.

the last time my brakes were done, one of the bolts that hold the caliper to
the spindle had to be replaced with a different one and force-threaded in..
being the hole is stripped... so now they need done again and I need a new
spindle... except this doesn't apear to be a part ...

    vehicle doesn't start with turn of key.  Have to 'hot wire'
by running a wire from the positive term. of battery to a terminal on the
 starter solenoid.(key in the run position)  Someone said the prob IS the
solenoid, but if that

"Jim Warman" <mechanic@tenalpsulet.net> wrote in message
news:762Ae.104730$HI.94302@edtnps84...