99 LM trani 'jumps' slightly into first coming to full stop... trani guys
say no problem;  never happened with old planetary  Town Car tranis...this
new electronic stuff is an irritant

was wondering if this could just be a line that broke or if i need to
replace something need help guys.

Replaced slave, master, and clutch.  performed bleed procedure 4 times.
pumping the pedal only gets minimum pressure.  not enough to move slave.
Any ideas?

I just completed replacing my clutch plate and pressure plate in my 1985
ford ranger, put everything back in place and when I went to test out my
new cluth and it would not start. The engine turns over but will not
start. I know the carb is getting fuel. I replaced my distributer ...

Before I start tearing stuff apart, anyone ever encountered a non working
odometer in a 94 vintage cougar? Speddo works fine, odometer and trip
odometer not working. Seems to hae stopped right after I reset it.
Mechanically, easy to get open? Easy to get out of dash?

i have a ford escort 1.6efi it will not start i can hear the fuel pump
clicking over it will start when it has been towed off then left for a
couple of hours it will not start again if i put petrol staight in to the
pump it will go it turns over by the key but just will not fire up ...

My 91 Town car will not shift from park after engine is started. I have to
manualy over ride the system as explained in the owners manual by turning
off the engine, then set the parking brake, then turn the ignition key to
the first notch, then pull gear shift lever to neutral, then ...

 Didja ever notice that work performed gratis for family is always the the most
frustrating.
 I did the rear drum brakes on the sister in laws 97 Taurus. Not rocket science,
although I was surprised to see drums instead of disc like my 98. New linings, drums,

I posted a problem with my 1978 Ford Granada last week.  Thanks to all
responders.  The air flow does change when I move the lever to vent,
a/c, heat, and defrost.  The hoses into and out of the water valve are
both hot.  I haven't checked the blend door yet but I did remove the

Does anyone have a sight that I can go to to purchase a ford shop manual
for a reasnable price. I don't want aftermarket if I can get ford. Thanks

I put aceton in last week. 3 oz to 15 gallons. It's still got a half tank so
I can't check the mileage yet. It's a 4.3L auto CPI injected. Stock truck
accept the 2/3 lower and edelbrock headers. I checked the mileage last tank
with cheap arco regular. I got 15 even. (in town only ...

2 scanners have shown no trouble code and that is why parts have been
thrown at the problem.  Three mechanics (two certified) have tried to
diagnose the problem so far based upon what their scanners read.  Their
scanners say there is no problem but the driver says different.

Anyone out there have any helpful hints for putting in a new heater
core for a 1998 Taurus.  Dash removal tips?  How long it took?
Anything would be great thanks!  The fun starts tomorrow!

I have a bear of a job ahead of me replacing the heater core in my tbird..
and I was wondering, is there any kind of "stop leak" product I might be
succesful in using to seal it up instead? There can't be much of a leak, I
never got a wet carpet I noticed, just a few wisps of ...

OK, my Key Fob has quit working on my 2005 Ford Eddie Bauer Expedition
(5 months old).    It was working great this morning then I went out to lunch
and it quit working.  Anyone got any bright ideas before I run it to the dealer ?
Thanks,