| Thread | Last Post | Replies |
|
| hearter fan problems on1991 Ford E250 van | 14 Nov 2005 15:43 GMT | 1 |
I have a 1991 Ford E250. This morning the heater/AC fan did not work on any setting. Later in the morning I tried the fan again and it worked on all three settings but after the fan is set to medium or high setting the fan gradually slows down to the low setting speed after
|
| ford mondeo diele turbo 97 heater | 14 Nov 2005 15:42 GMT | 1 |
hi i have a ford mondeo turbo diesel estate 1997. the heater has stopped blowing warm air . the temerature control seems to spring back when u turn to hot , and in the dashboard. there is a slight clump almost under the windscreen . can anyone tell me what is happening and how i can ...
|
| Info: The 1/4 tank to cool your fuel pump myth | 14 Nov 2005 15:32 GMT | 20 |
Contrary to what some believe, it's not necessary to keep your tank at any given level to prevent your fuel pump from "burning out". Inspection of any pump/sender assy will bear this out. If such were the case, the pump would be shaped like a large flat can and be right at the
|
| What is a good year for Aerostar? | 14 Nov 2005 13:26 GMT | 11 |
I'm looking for a late model used Aerostar, 4-7 years old. Is there a good model year? or a bad year to stay away from? Thanks in advance. Fred
|
| 2000 Taurus Coolant Leak | 14 Nov 2005 13:25 GMT | 3 |
Have a coolant leak somewhere under the radiator filler tank (mounted on the passenger side fender well) but can't see where. Any ideas?
|
| 1992 Escort LX | 14 Nov 2005 10:35 GMT | 2 |
My Ford EscortLX 1992 Stopped running on a four lane highway. It was running just fine, the it made a few little ping,ping noises and the motor cut off. At that time a gush of coolant poured out from the car. The car wouldn't hold coolant after that andthe car would't start up. ...
|
| Ford C4 automatic transmission modulator valve | 14 Nov 2005 03:08 GMT | 1 |
Hi, I would like to know the proper way to pick a modulator valve and adjust it. The trans came from a 1973 Ford LTD station wagon. It was rebuilt and is going against a hopped up 5.0 roller motor in a 1939 Ford. Right now it has 2 vacuum ports on the modulator. I would like to ...
|
| Best Year for Windstar to Buy | 13 Nov 2005 18:34 GMT | 2 |
Is there a year above 1996 in the Windstar that have been fairly good for repairs? What engine do I stay away from?
|
| Cleaning interior | 13 Nov 2005 17:19 GMT | 1 |
While doing a google for tire cleaning, I saw a couple references to using Pledge on the interior, the plastics and vinyl dash, I assume. Many of you use Pledge? Thought I'd ask to get more comments before trying it. Thanks.
|
| WILL NOT START | 13 Nov 2005 13:37 GMT | 6 |
IF I REMOVE THE BATTERY TERMINAL AND THEN PUT IT BACK ON AFTER A COUPLE SECOUNDS THE CAR WILL START SEVERAL TIMES AND THEN I HAVE TO REMOVE IT AGAIN WHAT COULD BE WRONG I HAVE A 1995 MUSTANG 3.8
|
| Ford Thunderbird 3.8 Engine Cooling 'Heater Problem | 13 Nov 2005 08:15 GMT | 3 |
I have a 1992 Ford Thunderbird and have taken care of it since I have purchased it new in 92. After a couple of years I learned of the Head Problems that can happen with these engines. One of the reasons is design and the radiator sets lower than some of the cooling in the
|
| 99 windstar O2 sensor | 13 Nov 2005 08:01 GMT | 1 |
How many O2 sensor on 99 windstar 3.8L ? Do they need to be changed out ? How many miles/months? do I have to change them all in once? Thanks
|
| Brrrrr..Cold | 13 Nov 2005 04:19 GMT | 1 |
99 taurus. 3.0 OHV. Very little heat inside car.Put in a flush tee,took opposite end of hose off heater core and flushed water through..had good flow..replaced themostat,radiator cap, and the water pump..I,d say heat works 10% better. What is the next step? The air is not very
|
| Ford GT | 13 Nov 2005 01:36 GMT | 10 |
Ford stands for 'Factory Ordered Road Disaster' funnily enough it is true, Fords are crap.
|
| ford escort starting problems | 12 Nov 2005 18:17 GMT | 4 |
hi, regarding my previous post, I just thought I would add. I know if the car wont start while I crank the starter motor as the rev counter needle does not move, if the rev counter jumps a bit while cranking it starts, I read
|