guys is there any problem with ford fusion, I am pretty close to make
decision in buying one, so if any reason why shouldn't or should I would
really like to know ;-))).
Also I can't find in any brochures is it 16V motor or is not! Salesman (of

Hi can anyone help ive got a mondeo 2 ltr auto which wont go in to gear
when you select any gear but the engine seems to labour slightly in gear
as it is trying to go in.
On checking the oil level it was empty filled it up checked it etc still

I HAVE AN ANTIFREEZE LEAK. I THOUGHT IT WAS THE HEATER HOSE AND REPLACED
IT, BUT I STILL HAVE THE LEAK. IT ONLY LEAKS OVERNIGHT AFTER THE CAR HAS
COOLED DOWN. WHAT WOULD CAUSE THIS TO HAPPEN JUST OVERNIGHT. THERE IS NO
LEAK WHEN THE CAR IS RUNNING OR WHEN IT IS STILL HOT. CAN ...

I heard that there is a tranny fluid drain plug on 97 escorts.
Cant see one, but does anyone know?
thanks

Ok.. I hooked up an Amp in my Ford Taurus, to the factory radio.. Worked
perfect.. My boyfriend (Whom doesnt know anything about electricity..)
Decides to touch a speaker that is connected to the amp, back to the factory
speaker out let... The speakers hum.. He lets them go.. ...

Ok.. I hooked up an Amp in my Ford Taurus, to the factory radio.. Worked
perfect.. My boyfriend (Whom doesnt know anything about electricity..)
Decides to touch a speaker that is connected to the amp, back to the factory
speaker out let... The speakers hum.. He lets them go.. ...

Anyone know of a source for replacement lower copntrol arm bushing and
shaft kits to fit a 1996 Mystique/Contour/Mondeo? The front bushings
are out of mine on both sides and I'd rather replace bushings than
lower control arms if it is possible.

after sitting all day or overnight, hard starting (about 2-3 seconds
cranking).  symptom like no fuel, but tried a test which presumably
would indicate fuel regulator, but passed.  Test was to turn on key,
wait 10 seconds, then repeat 3 times.  This had no affect, still was

My explorer came used without any of the tire changing items.  What is
the best way to get them replaced?  Junkyard, generic replacement or
dealer?  Jack, lug wrench, tire lowering tool, etc..
Any help would be much appreciated.

92' CROWN VIC MASS AIR FLOW SENSOR HAS A LOUD HUMMING NOISE.  REPLACED IT WITH A SALVAGE YARD PART AND HUM HAS DIMINISHED, BUT STILL THERE.  WHEN I TAKE THE MAF OUT OF THE LOOP (DISCONNECTING TOTALLY FROM THE AIR SYSTEM) NO MORE HUM, BUT ENGINE WANTS TO STALL AFTER REVING AND ...

Could anyone identify which are which - pressure and return lines? Also, in
regards to accessability would it be easier to remove the line from the
trans or the cooler when performing a flush?
A wee bit of background...My sister states that her trans slips/delays going

Hello there i have 93 ford aerostar electronic 4wd , i just changed the
trans but for some reason when i put it in gear...i have to give it
some gas for the gear to kick in....then works perfect, but when i stop
at idle it kicks out of gear...give it gas and boom back in it

Ford Windstar 2002 SE, has transmission cooler.
If more than 5 people in the car, on the highway on the small hills going
up, it turns off control-cruse and displays for few second "check
transmission" message.

I've got an 88 Mustang that runs fine, but on long trips (Chicago to
Indy) runs hot and vapor locks.  After 3 hours or so of highway
driving, she'll stall when we hit traffic.  A friend said that
installing or replacing the fuel injector would fix that. What do you

I have a 1994 ford taurus gl sedan.  The other day, while I was driving, it
just quit without any warning at all.  I pulled over to try to restart it,
but it would not start.  When I try to start it, it turns but will not
start.  The guy that towed it for me said he guesses that ...