Hi - I need to replace the left rear brake bulb in my 1997 Ford Ranger.  I
removed the two screws from the lens, but I can't figure how to remove the
lens itself.  It seems where is some kind of sleeve on the lens on the bed
side of the truck.

I have a 68 galaxie conv. with a 351c engine. I belve the car came
with a 302 acording to the vin. I 'm wondering what kind & what year it
is. block # D2AE-CA & 3624
intake # DOAE-9425-L , heads # D3ZE  AA  31975  3G25  3G31.  I know

Hey all,
I have a new to me 1995 mustang GT (85k) that I attempted to replace
the clutch.  I took the old one out and while I was at it, replaced the
engine rear main seal, the trans front main, shifter seal and trans

I have a 95 taurus that has a slight wobble when applying the front brakes.
I'm trying to replace the front rotors, but I've tried everything to get
them off to no avail.  Torch, wheel puller, PB blaster, bfh (big f#$%ing
hammer), no luck.    Any ideas.

My 95 Taurus has a problem with the speedometer needle jumping . It will not
hold a steady speed it always is moving back and forth around 5 miles+ or -
what the speed is. Anyone know what to check for and how to go about fixing
it

Rather than re-engineer the engine, I'm replacing the AC Compressor!
Is there ANY way to isolate the AC Compressor on a 93 Mustang GT?
Thanks, again!
Steve

Has anyone had any problems with the ECU on a UK model Fiesta 1.25 2001?
Keeps throwing up an O2 sensor heater fault code. has had both upstream and
downstream sensors replaced but made no difference, wiring loom seems to be
ok. looks like ECU. Any advice?

I see a lot of Ford Ranger pickups that track dow the road cockeyed.
The rear wheels are noticeably offset from the front wheel.
When moving in a straight line the body is forced into a angle that is
not aligned with the wheel track, especially noticeable when following one

http://tinyurl.com/l4uby
I am surprised Dell hasn't tried to link this to the Ford Crusie Control
Deactivatin Switch.
Regards,

Hi, i have a 1988 Merkur Scorpio,a nice car, but the front driver's
side control arm bushings need replaced.I went to my local Ford
dealership and they couldn't help me.Does anyone know where I can
locate a new set.Thanks In advance

this is an 1984 bronco v-6.
battery went dead so, son took one out of another car- it looked the
same and hooked it up.   only he didn't pay any attention to the posts
and they were opposites, so he reversed the leads, basically.

Hello, I recently bough a 2003 Ford Escape XLT 4X4 but it only came
with 1 keyless remote. I got a unprogrammed one for free from the
dealer, but don't know how to go about programming it. Does anyone know
how to program these things? Thanks a lot!!

Hello, I am replacing the oil pan gasket on a 94 Topaz.  I removed the
lower radiator hose and can move the secondary air injection hoses
aside for removing the pan, but as I pull the pan down and away from
the transmission it is catching on something inside the pan.  I've

I just purchased an early Ford van that is identified as a "Falcon" van.  It
has the logos on the doors and tailgate.  I can't seem to find a listing for
anything other than a falcon ranchero or sedan delivery.
It looks like an early econoline van, but it is original paint and ...