Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Ford / Ford Cars / September 2006

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
If Pigs Had Wings...30 Sep 2006 16:16 GMT1
If Pigs Had Wings
Marc E. Babej and Tim Pollak
Forbes
8/23/06
98 Windstar Intermittent Hesitation / Bucking ?30 Sep 2006 03:38 GMT34
I have a 98 Windstar 3.0 with 128k miles on it, and over the past few
months it has had a problem with hesitation and bucking.  The problem is
intermittent.
My mechanic has diagnosed a few things so far and a lot of money has
93 ford aerostar30 Sep 2006 02:36 GMT7
my problem is that on some days my van wont start so im thinking
distributor cap. now i took it to a repair shop and they said that was the
problem and also i need a tune up and wires and they quoted me $600.00 to
put new wires and new cap and air filter and fuel filter so my ...
oil pan hole(welded??)29 Sep 2006 05:53 GMT4
question?? on my 92 cougar 3.8,the can bottomed out in a sink hole and right
by the oil plug on the pan, it hit and caused a small rip or hole in the
metel on the pan,the plug itself seems fine the damage is about 2 inches to
the side of it in a flat part of the pan,is it okay to ...
95 TOWN CAR SPEED CONTROL INTERMITTENT--WHAT TO LOOK FOR ?29 Sep 2006 02:54 GMT4
FOR ALL THESE YEARS AND MILES, THE SPEED CONTROL ALWAYS WORKED EVERY
TIME.  NO "CHECK ENGINE" LIGHT (EXCEPT AT START UP, OF COURSE).
WHAT IS THE MOST LIKELY CULPRIT(S) HERE?   THANKS IN ADVANCE FOR YOUR
HELP!
2001 Taurus- any problem areas?28 Sep 2006 22:47 GMT5
I just bought a low mileage 2001 Taurus with the 3.0L pushrod engine
(Vulcan). My 1997 Taurus  blew the engine due to the "brown coolant"
problem, which I didn't know about until it was too late.
Anyone know if there are problem areas with the 2001 Taurus other than
97 Taurus Vulcan 3.0 overheating.28 Sep 2006 15:29 GMT4
Hi, all. New here, so please forgive.
I did a search of the group to see if any of the previous topics were
relevant, but didn't find one that fit "just right."
I have a 97 Taurus GL sedan with a 3.0 vulcan. My wife drives it as her
1961 Ford Thunderbird inner door panel parts-$1028 Sep 2006 13:28 GMT4
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=14003224802
6&ih=004&sspagename=STRK%3AMESE%3AIT

Taurus Wagon third brake light plastic, where to buy?28 Sep 2006 04:24 GMT12
Some smuck broke all the plastic, but left the bulbs working.
I'd prefer to avoid the dealer ($$$) and the junk yard, so I
wonder if anyone knows of an online source for such a part.
Thanks,
2002 Explorer XLT27 Sep 2006 16:21 GMT1
I have a 02 exp. 4wd. When I am driving above 35mph and take my foot
off the gas to allow it to slow down I feel the car jumping and doing
like a dong" noise. It's not hard for everyone in the car to feel it
but you know your car, I don't know what that might be. I replaced the
problem with alternator wiring on 1993 Ford Sho27 Sep 2006 06:06 GMT5
I think a wire came loose or the altenator may not be wired right.  It is
discharging my battery.  Need a diagram or a good instructions on how to
wir it correctly.  thanx
1994 Ford Taurus Replacing Air Compressor Pulley26 Sep 2006 15:59 GMT5
I have a 1994 Ford Taurus 3.8L V-6 GL Sedan. The bearing or clutch in the
a/c compressor pulley is going bad.
Since the car is old, I don't want to spend anymore fixing it than I have
too. I have been quoted $900 to replace the a/c compressor with another one.
2000 Mystique follow up26 Sep 2006 15:46 GMT7
2.5 Duratec
My dealer found a faulty fuel injector as the cause of the misfire/rough
running.  In the process, having to r/r intake manifold for the injector,
dealer said plastic IMRC bushings for a secondary intake runner control were
fenders for 93 crown vic26 Sep 2006 10:51 GMT5
I priced up fenders for a 93 crown victoria, they are over $300 CAD.  I
have bought pickup fenders before, they only cost near $100.  Is there
something driving the cost of these aftermarket fenders up, they seem
pretty simple... can't see why the cost is 3x that of pickup ...
Problem 99 contour sputters, stalling26 Sep 2006 08:18 GMT4
Contour 99 sputtering and stalling...sounds horrible.  used techron for
fuel injectors yesterday...ran car hard for 100 miles...car sputters while
driving, stalls when coming to a stop..not every time but becoming worse. i
had the car checked for leakage in the hoses...sounds like ...
Pages: 1 2 3 4 5 6 7 8 9 10 11 August, 2006
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.