I am trying to figure out why my moms radio does not work, it turns on
but there is just static? Does anyone have any ideas to trouble shoot
this problem or do i need to buy a new radio?
Thanks.

How much does a professional front oil seal replacement typically cost?

Hi all....am giving some serious thoughts to converting our 2006 Focus and
2007 4 banger Ranger over to E85 via conversion kits.
Both vehicles have less than 12,000 miles on the clocks.
Any forseeable problems? thanks....

When performing QA1, QA2 and QA3, and all the other pinpoint tests,
can I simply disconnect my PCM and test on the connector or do I need
a breakout box in order for the tests to be run properly?
Thanks!

Restored 1920 Dorris K-4
My Husband found it in a barn in Montana. After 4 years and
lots of work, his labor of love is 100% restored! The RV of my
Husbands dreams reaches a top speed of 15 miles per hour,

i replaced the pressure regulator on my 91 ford explorer and the check
engine light comes on when you drive after about 2 miles i had a code
reader put on to find out what was wrong and the reader said that
there was nothing wrong how strange any answers for this then when you

I just replaced the cooler line fittings on a friends 1998 Taurus SE
3.0L automatic transaxle/transmission, because they were leaking (one
of them.. but I replaced both). These are the fittings at the tranny.
It was not leaking after a short test drive (it was already warmed up

how much money has it cost you in the past month for the 46 email addresses
you have started to post your bullshit because people keep on blocking the
email addresses as you start them???
and when are you going to understand no one gives a rats a.s about your

My 94 Towncar will sometimes hunt in and out of overdrive for no reason. It
has nothing to do with loads or temperture. I suspect a sensor problem but
which one and where is it? Any help please.  All other shifts are normal and
there are NO other symptons. It happens any speed ...

I've been able to locate and remove the heater fan motor and assembly.
When I switch to power the fan motor will run normally for a few
seconds, but will subsequently experience a reduction in speed to the
point that it will not run at all at the lowest setting (position 1).