Where is the dropping resistor for the low speed fan on the radiator
located on a 1997 taurus?
bob

I have a 2003 3.0L Vulcan Taurus. The vehicle runs fine under normal
conditions, normal mileage, as long as I don't tach it up to 2500 to
3000 rpm, then it has major hesitation and sputtering.. When I drop it
down to under 2500 rpm, its all fine. This came on all of a sudden.

hey guys ...
Good sunday morning.
I got up early today, went and filled up my Biodiesel (it is always cheaper
and better then petroleum diesel given the astronomical prices that have

A couple weeks ago my radio in my ford fiesta started to behave very
strangely.
After around 10-15min of driving, the radio signal became weaker and
weaker and at the end I couldn't listen to any station at all. When I

The 65 mpg Ford the U.S. Can't Have
http://tinyurl.com/5p58tm
If ever there was a car made for the times, this would seem to be it: a
sporty subcompact that seats five, offers a navigation system, and gets

Both sets of pics are the same pieces from different angles. How are
the arm A and little nub B supposed to interact with the valve body?
Looking at the depressions in the machined piece on the valve body, is
the nub supposed to nest in one of them? And if so how do you

I have a 2003 ford windstar that keeps cutting off when you first
start it and for about the first 5 minutes of driving it. After that
it runs fine. It also has a squeeking noise. My husband changed the
belt and the pulleys. Also, he changed the power steering pump. Does

My ford taurus makes a weird sound when I am driving it, it doesn’t
make the noise when i first turn it over, only when i start to drive,
also it seems to get worse while making turns, my power steering fluid
was low and i refilled it, but I’m not sure what it could be...please

My 1994 Towncar will shift in and out of overdrive for no reason.
It happens after driving about 10 miles. I can feel and hear the change in
the engine.  It occurs at most any speed when crusing. All other shifts are
normal

I'd like to mount a two way radio in my 2006 Taurus sedan. I picked
the hump because it's the only good position I can find, without
leaving ugly holes all over the dash later...
Before I get started though I'd like some advice from you experts. Is

Garage just charged me a lot for a timing belt (2nd), new
radiator,warped head, gasket, etc.
I drove in a ditch to avoid a raccoon, and put a hole in the radiator.
The car is fine now ('cept for the body :+), and no engine lights come

I've got a leaking radiator on my Taurus, a '93 LX sedan with the 3.8 V6.
I see that there is both a standard and heavy duty radiator available.
My questions are, are the two interchangeable as far as physical
installation? Second, does "heavy duty" refer to increased cooling

I  bought this 97 Taurus in good shape with a blown head gasket. put
another 3.0L Vulcan in it. It starts and runs fine, BUT it runs over 3/4
the way + to the end line on the heat gauge. I flushed the transplant
motor before installation. Put a new water pump on it. New ...

Hello Ford Mechanics at large,
I own a 97 Ford Ranger and about two weeks ago the cab blower fan (for
the Heat and A/C) started to intermittently fail. At that time when I
started the truck, I would turn on the A/C, and noticed that the fan

I have a 98 crown my problem is when driving the car kind of jerks
back and forth and when i try to get on the freeway the more i push
the gas the more it rides ruff and the check engine light blinks when
its riding ruff also when driving sometimes at like 50MPH it feel like