The passenger's side power window has stopped working on my son's Z24.
When he brought it to me the glass was in the fully down position.  We
removed the door panel and plastic moisture barrier to find the
motor/regulator assembly is rivetted in place. Problem is to remove

My 97 Venture keyless entry system can "unlock" but cannot "lock".
Does anyone know what the problem is ?
Both two transmitters have the same problem. So is not a bad button.
Maybe it is out of sync ? If it is, can someone give me the instructions

As suggested by you folks (thanks) I visited the dealer to inspect the
alleged crack in the block. What I found was a spot about 1 and 1/2
inches down from the top of the cylinder against the wall. the spot
about the size of a dime was discolored from the torch they used to

I have a gremlin in my power door locks in my 2000 Monte Carlo SS.
At random moments in time the door locks on BOTH doors will try to
repeatedly lock. This will go on anywhere from a few seconds to a few
minutes at a time, then stop and not do it for days. Sometimes it happens

I have a 98 Grand Prix GT 4 door.  Common problem - we can not get out
of park unless we press the shift lock button.  My wife said at first
it happened only some time, and now it is all the time.  This makes me
think a bad solenoid?  I thought if it were a ground or something else

I am upgrading my 305 in an 85 GM truck to TBI. The current system has a
computer controlled carb and ESC ignition. Do I have to replace the existing
distributor or can I use the one in the truck. 85 G20 chevy van

Our 2002 van has just been used for normal family duties and rarely is
heavily loaded.
The front struts and rear shocks were so worn by 48,000 miles that the
vehicle pitched all over the place.

The editor from the New York Times called me last week. They wanted to use
some pictures from our website about a article they were doing on
automobile black boxes. We said sure...
Article came out today. 09-24-04, page D11. Yes, that is my hand and my

I replaced rear rotors on my 1998 GMC Jimmy. Its a 4X4. When I test drove in
it had a rubbing noise like the parking brake was dragging. I removed them
but it still has the noise. I am thinking real wheel bears. Any other
thoughts and what are the basics for replacing real wheel ...

With this 99 Cavalier, I've got a rear window defogger which just stopped
working.
No voltage at the two terminals that clip on the glass. Resistance in the
heater, it's not open.

I have a 1984 Riviera 307 with a Rochester 4bbl.  Rebuilt two carbs, new
plugs, wires, battery, cap, rotor.  It idles rough and generally runs
poorly.  exhaust sounds like it might be backed up, could be a plugged
cat?  any feedback and other ideas appreciated.

Been looking at december and january 03 and 04 and there are a great
number of posts that discuss the intake manifold and gasket.
Apparently this manifold can warp or the gasket can leak.....if either
happens would this give the appearance of a ...blown head gasket or a

I got an 98 Lumina with a 3.1L motor with 170000kms.  When in overdrive the
tranny will create a unusual shift between gears, seems like it slips for a
couple seconds.  this problem will occur at any random point but usually at
15km/h or around 70km/h. also seems to happen after ...

My 1999 Monte Carlo is starting to take much longer to generate heat.
It started at the end of last winter.  The car ran fine all summer so
it slipped my mind including AC working fine.  Now that the winter is
coming I would like to replace the thermostat.  Can anyone give me an

Took our 98 perfect running lesabre limited in to accomplish the
recent factory recall for the fuel pressure regulator....shortly
thereafter (one day) we had the check engine light come on...we
returned to the dealer who indicated that after putting the computer