| Thread | Last Post | Replies |
|
| P0442 + click,click,click on 2001 Cadillac STS | 31 May 2005 17:44 GMT | 3 |
I have a 2001 STS which recently turned on the MIL and shows DTC P0442. I've check the obvious (gas cap is on tight), and temporarily cleared the code. Coincidentally, I recently noticed that within a minutes of driving I
|
| rear hatch95 jimmy | 31 May 2005 17:04 GMT | 2 |
my rear hatch window wont open you push the botton to open it and you can hear it work but wont open wondering if any body has had this problem if so please help me i cant find away to take any thing of to get to it sience the hatch wont open
|
| OBD1 Connector missing B (diagnostic) pin - how to fix ??? | 31 May 2005 16:31 GMT | 4 |
1994 Buick Regal Custom has the 12 pin OBD1 connector. This connector is missing the B (diagnostic pin). All other pins are there. I was hoping to be able to jumper this to clear the SES history, and also to use as a diagnostic tool, because jumpering the pin to ground
|
| 1990 Chevy Lumina Euro 3.1 running hot and rough idling, loss of power at times | 31 May 2005 16:17 GMT | 2 |
I have a 90 Chevy Lumina Euro and my radiator fan won't click on until the temp. gage is almost in the red. Then it will click on. There are two relays for it, a primary and a secondary, we changed one but it still does it. We even switched them around and it still is running hot. ...
|
| Chevy Astro van liftgate lock stuck | 31 May 2005 13:53 GMT | 1 |
'98 Astro van has power door locks. Right side of rear window liftgat is stuck closed - left side unlocks OK. Any solution simpler an cheaper than a Chev dealer service dept.? Thx --
|
| Upper Intake Manifold Plenum - R & R | 31 May 2005 04:23 GMT | 2 |
Finished replacing the upper intake plenum...which had a coolent leak and the lower intake manifold gasket. Just wanted to say thanks to all who helped me out with information including Shep, for recommending autozone.com and jgalianojr....
|
| Computer Codes for Chevy Lumina | 31 May 2005 03:35 GMT | 1 |
I have a 90 Chevy Lumina Euro 3.1 and I was wondering how to do the paper clip trick to get the computer to spit out codes to see what is wrong with my car, overheating and loss of power at times then step on gas and it goes good. Do I even have a computer in the car to do that ...
|
| Help: 1992 Chevy S10 Blazer Intermittant Start Probs | 31 May 2005 03:19 GMT | 4 |
I have a '92 s10 (4.3l CPI) that sometimes will not start, acts like it's out of gas, has fuel pressure and spark. Will then start normally and run good after a few minutes. Sometimes on start, engine will race, and will not stop raciing until turned off. Have replaced coil, rotor ...
|
| 94 GMC Safari front end | 30 May 2005 18:45 GMT | 5 |
The front tires are both severely worn on the outside. The tire pressure is correct. When you turn it feels as if the tires lean. I am trying to figure out if the ball joints are worn out or what?
|
| turbo or supercharger | 30 May 2005 08:52 GMT | 7 |
i have a 98 4x4 chevy blazer 4.3 v6 i cant figure out if i wanna buy supercharger or a turbocharger. i heard turbochargers put out more h but superchargers are easier to install. anything to sway my decisio would help
|
| 94 Caprice | 30 May 2005 03:21 GMT | 3 |
Hi: Automatic driver side window is down and will not go up. Switc tests positive for power. Is there an emergency release to get th window up
|
| Malibu 2004 | 29 May 2005 21:10 GMT | 2 |
My Malibu 2004, with 19000 km on the meter, will not start when warm. It happens a couple of times a week and only when the engine is warm. The starter motor will turn furiously, but somehow not catch. After waiting for about a minute or so, the engine will suddenly start without ...
|
| 2003 Buick Century | 29 May 2005 18:44 GMT | 1 |
Does the 2003 Buick Century with a 3.1l V6 use a timing belt or chain? Thanks
|
| Chevy 250/292 exhaust manifold | 29 May 2005 05:13 GMT | 5 |
Can anyone tell me a source for a (quality) new 250 or 292 exhaust manifold (old style - not integrated)? Apparently they are an obsolete part for GM. Thanks.
|
| 2001 Venture OBD II Code | 29 May 2005 04:06 GMT | 2 |
Have a genaric code P0135.... checked reference voltage (good 4.95v) on the coolant temp sensor, the resistance seems to be inconsistant with data, should I replace the coolant temp sensor. The OBD II says the problem lays on "bank 1 sensor 1" this is what is confusing me.. what ...
|