I have a 2001 Prism that has a very slight tendency to "drift" to the
right if I take my hands off of the steering wheel.  I checked tire
pressure and all four are at 30 PSI.  Is this normal (it might have done
this before but I never noticed it) and if not, what could cause this?  

My daughter's '97 Cavalier, 2.2 4-cylinder (80,000 miles) quit running
Saturday; had it towed home.  The starter spins the engine over fine
but will not start.  Here's what I've checked so far:
1.  There is good spark at every plug.  They're gapped at .060", but

Have a '97 Buick Le Sabre with 60,000 miles on it.
Brought it back to the dealership today for an oil change, and they
recommended (strongly) that I also have a "transmission flush" due to having
60K on it.

I have a 2001 Oldsmobile Silhouette Premier and have recently discovered
that the rear HVAC blows hot air when the AC is activated. The front has
cold air coming from the vents, but the back has hot air blowing. The
temperature of the air is always hot, even though I have tried ...

My 91 park ave does not stay running and it seems to flutter when I hold
the gas on.  Turns over fine only stays running when I got the gas
peddle pushed down a little. Any ideas? Ignition Module?
Thanks,

 2.8 mpi '89 Cavalier has a slight but noticeable miss at idle, runs
pretty much normal otherwise.
 Plugs & wires replaced recently, new computer, several sensors (TPI
and I "believe" MAP).  

For some reason my "Exit Lighting" has stopped working. Any thoughts?
1999 GMC Sonoma.
Thanks  

   I recently bought a 94 Chev Lumina 4 door sedan
from a Chev dealer.  The body was in great shape (no rust
anywhere), runs great, etc.  I removed the spare "doughnut"
tire so I could see the condition of the jack, etc.  I was

Why the heck does GM make rear decks they way they do?!  You
practically have to evac the whole freakin' backseat just to swap out a
lousy pair o' 6x9s!!
Anybody here been in the back of their '04-05 'Bu and survived a

Didn't say you couldn't have 2.2L...just that a FWD 2.2L has different
casting of the block for the engine mounts. Haven't seen one yet fit into a
RWD application that came out of a FWD.

I have a 1988 Oldsmobile Cutlass Ciera that I would like to keep going
as the miles on it is not too high.  However the two front door has
rusted so much underneath and I want to replace them.  Seeing that
there aren't too many doors from the same model year that are rust

More importantly....my Saturn SC2 is up for it's first oil change soo
and I would like to know if taking it to any place for an oil chang
would void my GM warranty??? What about other general maintanenc
(brake pads, rad fluid, purchasing new rims, etc

accelerating at a green light my 98 cavalier made somewhat  of a slight
boom sound and the power steering was gone, the temp guage went directly
to hot, and the dummy light for the battery came on. I pulled over and
shut the car off, popped the hood and could see antifreeze all over

i have just reached 50,000 miles,and was suggested from a guy i know at
napa ,to change my fuel filter.it was running okay ,a little
sluggish,before i changed it. now that i have changed it,the car willnot
start at all.can anyone help me?

S-10 is out...block casting prevents installation in a RWD vehicle......