| Thread | Last Post | Replies |
|
| Radiator level switch | 28 Dec 2005 13:57 GMT | 5 |
I have to get a new radiator for my daughters Lumina, does the level switch come with it? If not how do you remove the old one?
 Signature Doug and Rox Ann Adams
|
| 2000 Buick Century Driver-side Heater Control | 28 Dec 2005 10:35 GMT | 7 |
My 2000 Century Custom has 2 control levers that independently adjust the air temp for driver and passenger. The driver's control lever moves freely but the air is stuck on 'heat' full-blast no matter what the lever setting. Occasionally, when the lever is adjusted, it will change ...
|
| 2001 Lumina Low Coolant Light | 28 Dec 2005 03:35 GMT | 5 |
My Lumina has plenty of coolant, but the Low Coolant light is on (goes out after ~30 minutes of driving). The car does not overheat. How is coolant level sensed? Is there a sensor that needs
|
| No heater display for 1995 Buick Park Avenue | 28 Dec 2005 02:12 GMT | 4 |
Can anyone help me? My display for my heater including all other controls do not work. I am unable to turn anything on including my rear defog. The fan is on and I am able to turn this up/down somewhat by using the temp switch on the sterring wheel. Any hints?
|
| Vortec 4200 (LL8) inline 6 dimensions? | 28 Dec 2005 00:52 GMT | 2 |
Can anyone tell me the dimensions (height, width, length) of this 4.2 liter inline-six? I am considering using it in a project but I understand it is a bit long. If I knew just how long (and high, wide I'm not so concerned
|
| S&J Auto Parts/Find Part | 27 Dec 2005 22:53 GMT | 2 |
I was wondering if anyone out there has had any bad/good experiences with the company below: S&J Auto Parts/Find Part Address:
|
| 94 Chevy S-10 Blazer | 27 Dec 2005 21:09 GMT | 4 |
Said SUV has V-6 4.3L Vortec engine and 4 speed automatic transmission. Intentions: At home, change the automatic transmission filter, replace lost tranny fluid, then have entire tranny flushed and replaced with new fluid. Problem: Unable to drop tranny pan as crossover exhaust ...
|
| 95" cavilier crank senser | 27 Dec 2005 15:54 GMT | 6 |
I was trying to change crank senser,it broke ! Can I take off oil pan ,and push out from the inside? Can someone tell me an easier way ? Any help would be helpfull.
|
| 1994 Buick park ave trunk | 27 Dec 2005 15:46 GMT | 6 |
I have a 1994 buick park ave and the other day i opened my trunk and it was full of water where it had been raining this happed when i first bought the call and the previous owner had itr fixed but i don’t know where the water could be comming in the trunk lid is seald good
|
| 2000 Silverado 4x2 issues | 27 Dec 2005 12:25 GMT | 1 |
Maybe you folks will have a few answers to my issues... I have a 4.8 v8 in my truck.. 185k miles (lol). For the most part my truck runs fine. Its basically stock with no modifications other then bigger tires and a very small lift (about 1" taller then a 1500HD)
|
| Pre 1921 Stutz Bear Cat | 27 Dec 2005 05:36 GMT | 1 |
Found an old photo album at my aunt's house today. Grandfather had a ' Project Car " when he was 19 or 20. A bomb of a Stutz Bear Cat 2 seater. The car was right hand drive too. One photo shows a bare chassis sitting on wooden saw horses. The caption
|
| Fan/Clutch Assembly | 27 Dec 2005 02:23 GMT | 5 |
I am trying to change the water pump on a 99 jimmy with a V6, I took off the bolts holding on the pulley thinking they were for the fan/clutch, but they werent. so how do I get the fan off? On the shaft there is what looks like a place were I could possibly put a 19mm wrench to ...
|
| Ourisman Chevy Dealer in Wash DC used to have 24 hr service | 27 Dec 2005 01:31 GMT | 5 |
I was reading an article which made the reference that Ourisman Chevy a well known dealership in the Wash. DC area used to have their service shop open for 24 hours a day. This 24 hour service took place back in the 1920's. Now my point is ...part of GMs big problem is customer ...
|
| 2001 chev astro | 26 Dec 2005 22:38 GMT | 2 |
I'm having a problem removing the power steering pump on 2001 chev astro mini van. I've removed all components except studs on the back of pump
|
| 1997 Buick Lesabre Hood Release | 26 Dec 2005 20:16 GMT | 3 |
I can't get the primary inside hood release lever to release the hood latch. How do I bypass this and get the hood to open with the inside release inoperative?
|