check engine light on and the code (on a snap on code reader) from the
garage says.. " ignition pulse " what the hell is this ? It is a 3800 v6. I
just had the tranny replaced and now the oil light is on (but sensor is
pluged in) and the check engine light is on.. sometimes I can ...

My guage floats all over so Today I got under the car and puled the
connectors around the tank.The first was next to a black box with a fuel
line running out of it and the other 3 were next to that.All I did was
disconnect each one and spray the plugs with deoxit and plug them back

'91 Bonneville with "moon miles" on it (249,000) is exhibiting what
SEEMS to be transmission slip under load, in overdrive only.
 IIRC the overdrive clutch pack slipping would likely result in the
eventual loss of third gear as well.

Hello, I have a few dash and instrument lights out on my Pontiac
Transport.
Can these be replaced easily?..Does GM stock these bulb?
Thank you very much,

I am trying to remove the rear view mirror on my Impala. The factory
service manual says; "using a flat blade tool, remove mirror". That's
it, no picture, no further instructions.
Well, I used a flat blade tool in everyway imaginable, and could not

My 1997 Skylark has been great; however, drove a short(10 mile) trip
around town today and two indicator lights lit up on the dash: CHECK
ENGINE and ETS OFF.  Does anyone know what the ETS OFF light means?
Vehicle has 140,000 miles with no problems other than routine. Thanks.

Good Evening,
I have a Transmission Code P1811 showing up on my 2002 Impala...
After checking the diagnostics and pressure readings, it would appear that
the Pressure Control Solenoid is defective...

Need to get to the emergency flasher switch.  Seems that the turns signal
are routed through the switch....the connector at the switch has become
loose, causing the flashers to work intermittently.  Do I need to remove the
bezel to get to the switch?  Is it just snapped in place? ...

I recently bought a used 95 GMC Sonoma extended cab pickup truck (4 X
4). I have noticed that after driving it and warming everything up that
the transmission shifts hard between 1st & 2nd gears. I have noticed
the fluid is a little overfull and appears dirty. Does any one think a

I suppose that the Mike Hunters of the world will now say this is a
brilliant move while in the past they have laughed at the idea when I
have suggested it many, many times.
http://biz.yahoo.com/rb/060906/autos_gm_warranty.html?.v=1

I just bought up a used 1987 car and I am trying to get it
safety/certified so I can drive it.  Could someone please tell me how
long a safety certificate is good for (to the MTO people when you try
to get your plate)?   If I get it say today, is it good for up to 3

91 olds 3.8L I need to find a free wiring diagram to trace the
distributor reference pulse from distributor to ECM. (Code "41" - no
pulse from/to) Or at least color codes for distributor wiring.
Can anyone help me? Point me in the right direction on where on

You guys are probably sick of hearing about inner tie rod ends but here we
go...
This is one thing I haven't done in the past and I definitely need to
replace the passenger side inner tie rod end.  Has anyone here done this and

Could someone please tell me if you own a 1987 vehicle, on which day it
will qualify to be exempted from the Ontario DriveClean emission test?
Does it mean that Jan 1, 2007?  Or does it mean Jan 1, 2008  when it
will be exempted?

My son through a baseball in the car knocking the rearview
mirror off the windshield.
Now get this... The adhesive between the baseplate and the
windshield did not fail; the glass did.