| Thread | Last Post | Replies |
|
| 95 LeSabre EGR Pintle Position Error is driving me insane | 31 Oct 2006 12:40 GMT | 2 |
Ok, here's the quick and dirty, My parents bought my wife a car from my grandparents at the beginning of the year 1995 Buick LeSabre Limited with the 3800 V6 obviously.
|
| 3.1L V6 FWD 5spd - how do you bleed the hydraulic clutch? | 31 Oct 2006 12:40 GMT | 1 |
I have a 1990 Beretta GT with a 3.1 and a 5-speed manual with hydraulic clutch. The pedal has to be pushed pretty close to the floor to engage the clutch fully, and upon letting it out even a little, it grabs fairly rapidly. I was told by the guy who rebuilt the transmission a ...
|
| 92 Cutlass Ciera cold idle problem | 31 Oct 2006 06:19 GMT | 9 |
Hi all: I've got a 92 Cutlass Ciera that, since undergoing a recent major tune-up, has been exhibiting a cold idle problem described as follows: About a minute, or so, after a cold start, when the initially rapid cold-idle speed normally ratchets back to warm-idle speed, the engine ...
|
| Car will not start when hot | 31 Oct 2006 01:33 GMT | 6 |
I have an old Chev with a 350 motor. If I drive the car on hot days or get tied up in traffic and then turn off the car it will not start for about 20 minutes. Any ideas why? What can I do? Thanks for your response
|
| 2000 Impala again--Class 2 data | 30 Oct 2006 21:22 GMT | 1 |
Update: I tested Pin 59 of the PCM to the "splice pack" under the dash, and the Class 2 data from the PCM to that pack doesn't even return a resistance value. That would explain the cluster acting dead, the security
|
| Code Reader | 30 Oct 2006 16:16 GMT | 5 |
Anybody know of a good code reader for the OBD2 systems ? I was thinking of a good one, because I will probably use it allot. Maybe a more deluxe one is what I
|
| 20 W 50 Usage | 29 Oct 2006 19:28 GMT | 12 |
What would on use 20 W 50 motor oil in? I found an unopened case ( circa 1998 ) in my uncles garage. Both his cars used 5 W 30 and the 88 Kawasakis used 10 W 40. At least that's what the dealer recently installed in it.
|
| ATF in PS Reservoir | 28 Oct 2006 18:27 GMT | 2 |
I added about a 1/4 cup of Mercon V ATF to my PS reservoir. Immediately realizing my mistake, I siphoned out all of the PS fluid and ATF in the reservoir and refilled it with PS fluid, I then siphoned out all of the fluid again and refilled it a second time with PS fluid, I then ...
|
| natural frequency of vibration measurement | 28 Oct 2006 11:48 GMT | 1 |
It is known that car wheels create vibrations in the car at their resonance frequency when the wheels are not balanced.Is there any method to find the rersonance frequency of wheel unbalance vibrations?How to know at what speeds the vibrations will occur?Will
|
| 98 Lumina Water Pump | 28 Oct 2006 03:45 GMT | 2 |
Friends, I'm in the middle of replacing the water pump on a 1998, Lumina, 3.1, sedan. I have a few dumb questions (the only kind I know how to ask). 1. Does the little raised triangular stud on the pump signify the top?
|
| What a Drag | 27 Oct 2006 17:40 GMT | 7 |
'93 Grand Prix 3.1 automatic. 110,000 miles. This car hasn't been driven much since I got a job 37 miles from home and I got a Grand Am because of better gas mileage. I do drive it a little each month to keep it working. It is always stored under cover.
|
| 89 Cadillac Deville Cooling fans keep running | 27 Oct 2006 13:36 GMT | 1 |
If anyone has any ideas to save me some grief it would be very appreciated. 89 Deville, turned the car off and the cooling fans keep running. Is there a relay or sensor of sometype to correct this ?
|
| Diag connector 95 Pontiac | 27 Oct 2006 12:06 GMT | 7 |
I have a 95 Pontiac and I wanted to dump the error codes on it to find out why the service light was on. I went to the connector under the dash, and you're supposed to be able to ground the 'Diag' pin at "B" to ground at "A" and it
|
| Lights off for 30 secs | 26 Oct 2006 21:44 GMT | 11 |
As usual, I turned on the car this morning but all the lights were off, including the ones in the instrument panel and the headlights. However, I could shift gears into D/R and the car could move. After roughly 30 seconds, the lights went on as if there was no
|
| GM Quick-Connect Fitting for Fuel Filter | 26 Oct 2006 02:40 GMT | 4 |
I changed the fuel filter on my 2001 Pontiac Montana. When I removed the inlet hose (that has a quick-connect fitting) a small black sleeve fell out of the hose. I tried to replace it when re-connecting the new fuel filter, but it wouldn't fit so I left it out. There is no leaks.
|