1996 S-10 2.2,I recently had a 141 code O2 sensor at the rear of the
catalytic  and after replacing the sensor, I notice the scan tool was
then showing close loop, but moments later " 5 mins" it would go to
open....... monotering the LT trim was at 114 and the ST Trim it was

Good morning,
This vehicle has 98000 kms and has been running great...I pulled out into
traffic this morning to pass, pedal to the metal...All of a sudden I lost
about 90% power...down to a crawl...

Several online sources  (auto parts store , garages )  have recommended flushing and
replacing brake fluid at intervals of 24 months / 24000 miles citing fluid contamination
andmoisture retention as primary reasons....and to purge any air as
secondary reasons, unless the system has ...

While changing the ever breaking rear door handle on my Astro van, I
put it back together without putting the latch rod in well enough.  The
result is that I can't get the door open to take it apart again.  Since
there is no interior handle or access panel (you get to it from the

Don't know what's going on, Failed the HC ppm Reading of 138  pass is
79.  and failed CO% Reading was 2.71 and pass is 0.42  on my 1992
Buick LeSabre 3.8L

I have two codes showing on my 1994 Buick OBD 1, 3800 engine.  Code 26
and code 56.   When I look in the Hanes manual neither of these codes
are shown.  Can anyone tell me what these two codes represent?   Thank
you.

When the warranty on the battery expires, so will all trade-in value of the=
used car.  That is about eight years from the time you roll it out of the
showroom.  There will be no used car market for this species of car even
after only five years.  Second hand owners don't have ...

I recently brought my old, decrepid van into a Tuffy Service Center
because it was stalling on the highway and would not start up after it
had stalled.  Tuffy said that the crank positioning sensor needed to be
replaced ($230 for part(s) and labor).  I had them replace this.

I was backing out of the garage the other day, you know like in a hurry!
and well .. I clipped my mirror!! And so they want $200 for a new one. It
seemed a bit expensive to me so I wanted to find out how I could fix it
myself when I came across this webpage check it out.

I want to install a bolt into a stripped thread.  I'm going to use a  
helacoil.  I don't have the install kit, but I have the helacoil
inserts.  I don't ever have to take these bolts out again.  My plan is
to drill out the hole, rethread it to the same thread as the outside of

Parents of 15 year old find $71,000 (US $ CASH) hidden in his closet.
Does this headline look familiar? Of course it does. You most likely
must have just seen this story recently featured on a major nightly
news program.

http://www.hybridcars.com/general-motors.html
you can't let Toyota rule the roost here continually

OK we have seen the First Ever G6 and said Blahh. And blahh to everything
else under $30k. When or Will GM make a stylish car for the common
man...Lord knows that this country is already flooded with Micky Mouse
styling cars especially under $30k. Camary finally has come out with a

I'm working on a 90 Cavalier Z24 the passenger
window is coming out of it's track. I opened up the
door panel and saw the front window guide is gone.
There is a hole in the glass where I think a guide