| Thread | Last Post | Replies |
|
| '91 Civic Si radiator upper tank split | 16 Nov 2004 02:43 GMT | 5 |
The upper tank on my '91 Civic Si radiator has a split 1" - 2" long immediately above one of the two brackets that support the air intake horn - the one closest to the battery. (And, no - I haven't leaned on the air horn in the past, though that kind of pressure is what
|
| 89 Honda accord Carburetor/fuel delivery problems? | 16 Nov 2004 01:52 GMT | 7 |
Hi, I have an 89 Honda accord LX. with a carburetor. and I am having some serious issues with this and they are quite puzzling. ok, ONe day i was driving and it just starts bogging down the car would run but with the gas pedal to the floor it will only go up to in between 1000 - ...
|
| Question about non-Honda ATF | 16 Nov 2004 01:33 GMT | 1 |
I know that using non-Honda ATF can cause poor performance while it is present, but can it actually cause lasting damage to the transmission?
|
| Civic Pining | 16 Nov 2004 01:20 GMT | 2 |
My 97 Civic pings no matter what grade of gas I use and the Honda dealer doesn't know what the problem is. The car has been tuned and valves adjusted. Any ideas? Dave,
|
| Remote door lock on civic coup? | 15 Nov 2004 22:46 GMT | 3 |
I recently bought a 2001 civic coupe (european model), and it has central locking with remote control. But it 's a shame that I cannot "see" when the doors lock. On my previous car (Accord) the indicators would blink twice when locking, and once when unlocking. Now, if I'm not sure ...
|
| 95 Odyssey burning 2 qts per oil change ?? | 15 Nov 2004 21:43 GMT | 3 |
My Odyssey, with only about 75K miles, is going through almost 2 qts of oil per change (every 3000m). So that is about 1 qt of oil per 1500 miles. This seems excessive to me. The car runs fine and there is no obvious oil in the exhaust smoke. Is this something to worry about? The ...
|
| Civic Timing Belt Saga - Continued | 15 Nov 2004 20:04 GMT | 6 |
So here I am, back again. Hat in hand, looking for ideas, or at least some reassurance that I didn't totally f&*(ck up my poor little 98 civic LX (D16Y7). Since the timing belt job, I have gone thru 1 tank of
|
| '88 accord lx low beams not working | 15 Nov 2004 20:03 GMT | 4 |
I have a big problem with the low beams not working. At this point I have adjusted the high beams to point down until I fix the problem. I have checked all the fuses and didn't see any missing or burned. I just got this car and have done everything to get it on the road ASAP. ...
|
| 90 Accord EX | 15 Nov 2004 18:25 GMT | 4 |
I have a 90 Accord EX, love it!!!! Very clean car, even w/ almost 200k miles. The car is having a hesitation problem when taking off from a dead stop. It does seem like you can throttle through the hesitation, b/c once above 30-40mph it runs great. It also does it when cruising and ...
|
| 90 Accord codes | 15 Nov 2004 17:03 GMT | 2 |
hey there I have a 1990 accord LX with only 120 km's on it and it will not pass aircare. It reads high Hydrocarbons on idle and that is the only test that they can do on this car cause it is too low to Dyno it so the only way that I can make it pass is retarding the timing. So i ...
|
| Civic 2005 | 15 Nov 2004 16:49 GMT | 3 |
What do you think about this car? Any issue I should know before I bought it? Many thanks!!
|
| Need advice on Accord Coupe V6 2003 | 15 Nov 2004 08:23 GMT | 4 |
I have in view an (in my opinion) excellent deal, a 0 km Honda Accord coupe 3,0 l V6 full options for 15,000 euros (old model). I have other Hondas (S-2000, Prelude, CRX) but I have no idea how this 6 cylinder engine is working out.
|
| 1999 Accord V6 EGR low flow fixed | 15 Nov 2004 04:03 GMT | 2 |
Just wanted to relate that the cause of the low EGR flow on my 1999 Accord V6 was intake manifold passages that were almost completely blocked with gunk. The RGR passage fix was done around 40k but at 101 k it was almost blocked closed. Removing the intake and cleaning the ...
|
| timing belt question... | 15 Nov 2004 03:20 GMT | 1 |
sorry about the blank post, hit enter instead of tab... anyway, gotta pop in another timing belt & water pump on my 92 accord, what do you honda guys use to immobilise the cam shaft whilst replacing the cam seal??
|
| 2001 Civic Max Alloy wheel centres | 14 Nov 2004 21:28 GMT | 2 |
Can anyone recommend a good way to keep the centre discs from falling out of the alloy wheels ? I have had the car for 3 yrs and have had to fork out on 6 centres so far Why did they make the like that !!!
|