guys,
I've got an A/C  pipe leaking Freon ( the one in front the evaporator )  on
Honda '93 accord.
It's actually a tiny hole in it and hate an idea of spending $300-$400 to

http://www.tegger.com/hondafaq/misc/old-bushings/
The numbered pics were taken before I started the job. I had plans of
adding this to the FAQ, but due to the intensity of this job, I decided to
just concentrate on doing it right.

I recently had a stuck thermostat at an inopportune time, and had to get
whatever CarQuest supplied the mechanic instead of OEM as I had figured
to put in when I replaced the coolant later this summer. I still have to
replace the coolant and bleed the system, which wasn't done ...

I have a '99 Civic (manual trans) with 68K miles.  When I was driving on a
long trip this weekend, with a lot of stop and go traffic, my car started
to make a loud grinding sound and rattling when I would use the
transmission to slow down the car- either downshifting or taking my ...

I bought a used 1991 Honda Accord DX Coupe recently, and it has been giving
me problems. Sometimes the engine would stall while driving, and I have to
restart the car. This happens both at signals and on the highway. It also
sometimes would not start after parking somewhere.

The car is overheating (needle points to red line) idling in traffic. When I turn on
the AC, the temp is fine. When I turn ignition off the condenser fan kicks in. I then
drive home and remove the bleed hole and find no trapped air (temp dial is set to
HOT.) I then remove the (92-96 ...

I drove my '90 Civic EX sedan 1.6L (180k miles, 5spd) on a 65 mile trip
last week (averaging 75mph, 3.5-4k rpm, no AC, ambient temp 85) and
about 5 mins after I pulled off the highway, the temperature gauge
slowly climbed to 2/3, up from its normal position at just under 1/2.

My engine check light came on and the ODB code indicates restricted EGR
flow.  Looking briefly I see what appear to be sensors in the exhaust before
the cat con and in the cat con itself, but I do not see the EGR valve nor
the line to it.  Anyone familiar with these enough to tell ...

Hi, I am gonna try to change the brake fluid in two Civics. One is
1997, the other one is 2001, both are LX, 5 speed, no ABS. How much
brake fluid do I need foe each? I plan to use a syringe to extract the
old fluid from the reservoir, then add fress fluid and flush the lines

when it's usually over 1500-2000 rpm.
I have to check the fluid level (I don't know if the previous owner ever
changed it) and also check the exh. pipe - but there is no noise if the car
is not moving no matter what the rpm is.

http://www.tegger.com/hondafaq/misc/no-rear-suspension.jpg
I'm off to the machine shop tomorrow to get the bushings pressed out.
This has easily been the most frightening job I've ever attempted, mostly
due to the amount of disassembly required. Ain't nothin' left of that back

Marre de payer trop cher vos carburants???!!!
http://economagnet.citeheb.com/

Hi Need help.
1998 civic cant get a/c to work. replaced compressor & clutch assmlbly 3x
...for some reason the clutch wont engage while trynig to add freon. if I
jump out the points on the relay it works.. Any ideas?

Sometimes when we lock the car the central locks work, other times they
don't. I was going to pull the assemblies out of each door to see if the
connections were tight. Anything in particular would cause this?

My Niece has a 91 Prelude, about a week after the stereo installers
got done with it, all gauges (tach, fuel and temp) are at the low end
of their scales and the turn signal and high beam indicators are half
light, untill you turn on the high beams, then the high beam indicator