I removed all head studs, belts and even removed the cam and the head
still won't come off. I even went as far as beating it with a plastic
mallet - doesn't move a hair. Removed still the entire intake manifold
with no progress. Sprayed the hell out of the seam with PB blaster. ...

Hey all and thank you in advance for your help.
I am hoping someone out there has a code book and can look these up
and advise me on the proper part.......
I had a local shop hook up a computer and gave me theses codes but I

I'm replacing an axle on my '88 Acura Legend. Both outer CV joint
boots were torn, but I believe only the left axle was making noise.
(Noise was mostly in right turns, and it sounded like it was coming
from the left.) I am also noticing that the upper ball joint boots are

Hello, all.
  I have a 93 Accord and the both the left and right headlamps keep going
out. In other words, the new lamps last about two months with very little
night driving before blowing. Does anyone know what could be causing this?

This after putting $1000+ into it last year for a new gas tank,
radiator, brakes, and timing belt/water pump :^(
I dropped it off at the dealer for the following problems,
and here's what they said:

I have a '99 Accord and I need some info on adjusting the throttle
cable. The cable has some slack in it which causes the car to lurch
from a stand still. Can give me some directions on how to take the slck
in the cable? Thanks!

I have a copy of the May 2006 issue of Car and Driver (magazine). The
magazine has an excellent article beginning on page 58 related 6 foreign
made cars that cost about $15,000 per car. They are really small cars (aka
economobiles).

I read from the manual owner book and there is not much info about this
function. Anyone can help me out? Thanks a lot!

My 05 Accord Hybrid has always felt like an iron slab on turns.  It
holds steady but the front slides out like it's driving on sand.  Based
on tire wear and the mark it leaves on smooth surfaces, I can see that
it's taking turns entirely on the outside edge of the outer front ...

I need to remove seat so I can get a panel off to push out a dent.
Thanks

Could someone let me know the correct timing procedure for this car.
My accord is a automatic and has the distributor with the two vacuum hoses
on it.
I tried per a Clinton manual and it indicates to remove and plug the two

I bought a1988 honda civic and the one I bought it from said it needed a
distributor.I bought a new one and put it in .Still it will not crank.I
put another main relay and wire harness on it it still will not crank.It
turns till the battery goes dead,but it acts like its not getting ...

Good day!
Well, I was wiring up a supplemental brake system to make our Odyssey
towable behind our motorhome and in doing so was messing with a few fuses
trying to find the right place to tap in the electrical.  My wife just

I have a 2003 UK Honda CR-V with factory fitted Radio/Sat Nav unit. I want
to
remove the unit to fit an FM Modulator to it but can't see how it is removed
from the dash.

I have an '05 Accord LX 5M, and I am looking for URLs that give some
idea about fuel consumption at idle (gallons per hour?) with minimal
accessories.
Anyone ever done a web calculator with BSFC @ load and RPM with other