| Thread | Last Post | Replies |
|
| Door Locks & Defoggers ? | 15 Jun 2009 04:42 GMT | 58 |
Hi; I have a 91 Civic and I will soon be shopping for a more modern used Civic or Corolla. There are two things I don't like about my car that I am hoping to get
|
| honda s600 chain final drive? but why? | 14 Jun 2009 18:24 GMT | 8 |
turns out the old Honda s600 little sporty cars had a differential and half shafts in the rear, but then little sealed chain drives from the end of the half shaft to the rear wheel on either side. ???? just to reduce unsprung weight?? only reason i can think of.
|
| Tire rotation neglected on 2000 Accord LX | 14 Jun 2009 15:30 GMT | 24 |
Tire rotation has been neglected on the car since they were purchased about 2-3 years ago. The front tires are worn down but the rear tires are fine. Would it be ok to rotate the rear to the front and front to rear since being FWD the front takes the most wear? or would that be a
|
| 08 Fit AC temperature differential is? | 14 Jun 2009 15:29 GMT | 5 |
What's the "optimal" temperature differential for an 08 Fit? Some people think that an AC unit should blow the same temperature whether it's 85 or 105, but I know better. How much should I be looking at. Yes, it's a small compressor, but
|
| Reliability of 2003-2005 honda hybrids? Used car shopper here. | 13 Jun 2009 20:41 GMT | 3 |
I just had my Echo t-boned, and I noticed a few Honda hybrids in my area being sold in the ~100k miles and 2003-2004 range. One I'm specifically looking at is a Civic Hybrid, 2003, with 9x000 miles, for $7888.
|
| 2001 CRV hard on tires? | 13 Jun 2009 04:19 GMT | 13 |
My Wife's 2001 CRV has 108k and on it's 4th set of tires. The Coopers have lasted the longest and seem to be going to last for awhile. The Bridgestone tires did not last very long. My Rav4 uses the exact same tire, except in size that the CRV uses. I still
|
| Hydrogen Fuel Car - Can You Really Build Your Own Homemade Hydrogen Fuel Car? | 13 Jun 2009 00:47 GMT | 1 |
Hydrogen Fuel Car - Can You Really Build Your Own Homemade Hydrogen Fuel Car? http://automotive-industry-news.50webs.com/Hydrogen_Fuel_Car.htm
|
| Driven: Honda S2000 (Road test - GT100) | 12 Jun 2009 13:11 GMT | 4 |
Honda's birthday present to itself is now ten years old. To mark this event Honda has released a batch of 100 specials editions in the UK. We took the opportunity to say goodbye. Read More: http://rss.feedsportal ...
|
| How to Remove 93 Del Sol Windshield Cowl | 12 Jun 2009 12:34 GMT | 4 |
How do I remove the lower windshield cowl on a 93 Civic Del Sol? This is the plastic cover below the windshield. I see how to pull the clips at the top of the cowl, but many of the clips for the rubber hood gasket appear to extend into the vent. Do I just pry and snap them
|
| Water Powered Cars Will Never Work | 12 Jun 2009 04:56 GMT | 2 |
Water Powered Cars Will Never Work... http://www.uretima.info/2009/06/water-powered-cars-will-never-work.html
|
| PO135 | 12 Jun 2009 02:20 GMT | 3 |
Can't seem to get rid of this code as it keeps reappearing and have replaced the bank 1sensor . I have been trying to find what voltage readings I should have on the vehicle side plug to the 4 wire bank 1 sensor as my manual does not seem to indicate that. I have 12 volts (key ...
|
| Islam | 11 Jun 2009 15:46 GMT | 1 |
Excuse me Would you stop for a moment O...man...Haven't you thought-one day- about yourself Who has made it
|
| front wheel bearings. | 10 Jun 2009 18:46 GMT | 7 |
I just put front axles in my 89 civic LX and while I was doing that I noticed some play in the hub. I plan to replace both front bearings but have some questions that hopefully can be answered here. Are the front bearings pressed into the hub? because I can find bearings
|
| PO135 | 09 Jun 2009 20:21 GMT | 1 |
Can't seem to get rid of this code as it keeps reappearing and have replaced the bank 1sensor . I have been trying to find what voltage readings I should have on the vehicle side plug to the 4 wire bank 1 sensor as my manual does not seem to indicate that. I have 12 volts (key ...
|
| ping Tegger--door edge guards | 09 Jun 2009 20:16 GMT | 1 |
Hey, have you put on any factory door edge guards? We grabbed a set for my dad's Acura. What is this "seam sealer cutting tool" they include? What does it do, and why do I have to do it? From the instructions, it looks like it just roughs up the inside of the
|