What does "235/75SR15 C" versus "235/75SR15 SL" mean? I know what the
numbers stand for, but what about the SR, C, and SL?
TIA
Hank

I bought the besttop trunk enclosure to create a covered trunk in the back
of my Jeep - however, i often have lots of photo equipment back there -- now
the weakest point is the tailgate lock that came with the jeep.
I would like to put a couple of loops - to install a padlock on the

I went out to Calico this weekend and hooked up with a bunch of guys and had
a blast!!  This was my first time out there.
I was wondering if anyone had a map of the trails there.
Thanks in advance

I want install a 84 302 with the  stock t150 trans and dana 20 in a 79 cj7.
I need to know what year bellhousing to use. and what vehical it comes from.
i know that the ford housing will bolt to the t150. any info would be
great.....THANKS

This has been talked about many times here but I am wonder what is the
cheapest simplest engine tranny swap for a CJ that will give 200+
horsepower. I would like to stay away for electronics and computers etc..
because donor vehicles are hard and expensive to find around here. I ...

After the discussion here over the weekend about AX15s needing GL3 lube,
while I was at my Jeep dealer today I asked their normally sharp parts mgr
what they were using in the AX15s. He came back with a lube for the 3550.
Anybody know what this stuff is? I looked at a quart and didn ...

According to some research:
"The chassis serial number is shown on a plate located on the right side of
the dash in front of the passenger seat, or under the front edge of the cowl
above the glove compartment."

When I put it into 4WD High a light saying "part time" lights up.   From my
experience in snow, sand, whatever, it appears to be in 4WD all the time
when it says that.
Also, is there a difference between the type of 4WD it's in when it's in 4WD

hey everybody-going to replace the ball joint on my dana 30 front
axle.  does anyone know what the socket size is for the upper ball
joint castle nut? the biggest open wrench (for sizing only) is 1-1/4
and it's a little too small.  thanks!

subject: jeep cherokee 2000.
I'm familiar with using a thermometer to check the output temp of A/C,
what is the recommended temp range I want to see with a temp probe down
in the center vents?  (assuming doors open, blower on high)?

I have a 2000 wrangler sport that I bought used. It has a hard top and
was supposed to include a softop. The only softop pieces i acquired
are the L shaped rubber pieces that fit above the full steel doors.
What other hardware pieces do I need to purchase a softop. The replace

Crap, my wife just got home and was complaining about really hard shifts
so we had a look and the fluid was empty in the clutch reservoir.  Put
some in and have a clutch again, but....
I haven't ever looked, but I bet my 88 has that damn internal slave.

Best Top is what im looking at.
Any experience with the "sail"top for the TJ? Thats the one im interested in
but is there a better choice?
thanks

I purchased a AGR Rock ram system for my 1998 TJ. (4" suspension lift)  I am
currently exploring mounting options for the ram cylinder.
Has anyone in the group installed the rock ram on their TJ? If so, how did
you mount it? I am concerned with performance with the suspension in ...

One of my good friends is moving to Salt Lake City, UT in the next few
weeks and is looking to purchase a Wrangler once he's settled in.  Are
there any good Jeep specialty shops in the Salt Lake City area he
should look into?