Slightly off topic, but maybe some of you have a Toy, or a neighbor who does...
so here goes my Q.
I am forced to replace a tow hook that was stolen off my 1993 Toyota 4x4 PU.
I had 2 hooks on it. One was the 93 factory single hook.  I was also given one

Howdy folks,
My 2000 TJ's wiper motor is going out.  I am lucky to get the wipers
going when I start the jeep, and loathe to turn them off as they require
getting out and manually giving them a bit of a push.

My idle has decided to run amok.  My Jeep mechanic guru has swapped  out the
"idle air control motor" and it seems to make no difference.  The engine will
idle properly in the 6-700rpm range for a while then it will surge to anywhere
between 1000 and 2000rpm and remain there ...

Well, I got home tonight and started looking at the new carb.  Next thing I
know, I'm half way into the install -- I intended to do this tomorrow.
Anyway, the install went smoothly enough, knock on wood.  So I attempted to
tune the carb, and it seems to be running really nice.  So ...

my 97 4.0l inj wrangler has developed a fault ....
it starts but as soon as i press the throttle it stutters and
backfires.
plugs changed, ignition leads and distributer cap changed

Vehicle: 98 TJ Sport w/auto trans.
The torque converter is not locking up when it's supposed to (over 40 MPH).
I have an error code (0740) which confirms it.
Is there a way to check the TCC solenoid without pulling the tranny pan?

Need source of custom flex plate for 86 XJ Cherokee with 2.8L
(externally balanced).  Need a heavier duty flex plate than OEM as I've
torqued off 4 of them over the years.
Any sources (including NHRA spec'd.) would be appreciated

This Jeep chick I know says she wants to mount her Hi Lift to the top of her
hood.  I don't think I have ever seen this done, and a quick Google search
didn't turn up anything.  I have seen them mounted underhood, I don't feel
too good about that (jack is hotter than hell when you ...

Thanks for the advice so far in installing my new Weber carb!  It
arrived today.  I'm at work right now, but I opened the box and looked
at the instructions, which say that the two gaskets should be coated
with proper sealant, or grease.  What is "proper" sealant for this --

I will be hosting a trail ride and campout for people who are in my area. It
will be easter weekend. We will offer onsite tent camping. We have 600 acres
and don't mind company. This is a friendly get together. All rigs must come
on their own power no trailer rigs as there is no ...

 Now that CJ is out of garage with new tranny, and it rained for the first
time yesterday, I have a wiper problem, they work when they feel like it,
not when I want them to. Anywhere special I should look, or just start at
the switch and work my way forward?

There is some sort of drain hose, about 1/2 inch in diameter that goes
through the hump, inside the jeep, just behind the shifters.  It is not
hooked up to anything, but looks as if it should be.  btw, this Jeep has
ac.  Any idea what the hose is?

The sky was dark
The clouds were grey
She said "Let's go 4 wheeling
To celebrate your day"

My inline 6 cylinder on my recent purchase of a 1994 Cherokee has
fantastic power-much better than I expected-but I get a distinct
knocking sound during most operation, especially when cold.  The
engine oil is fine.