hello there! does any one here have any experience with one of these? i'm
looking to replace or rebuild my oe steering box.  i have an 85 cj7.  i've
heard that i can use a gm or camaro box as seen here
http://www.cjoffroad.com/writeup.asp?WU_ID=17&noAdd=1

Does anyone use their laptop in their Jeeps? I was going to try and use
my laptop with my GPS, but if my Rubi's own computer ties in and finds
this NG, then discovers that it's not a Real Jeep...well, I'm concerned
about future performance and general attitude. Is there such a ...

Does anybody have the original camshaft specifications for the '76 CJ-7 258
6 cylinder engine?
If I need to replace mine, what are good grinds to consider?  Crane makes
one for a 1000 RPM starting point that's made for fuel economy and another

As some of you may know by now I am doing a 4.0L head conversion on  a 258.  I just put the new head on, bolted it down...everything went well.  Now I'm re-installing the push rods and rocker arms.  My question is:
I replaced all the pushrods in the same position they were in when ...

dumb a.s that i am, i lost the key to my 03 sahara. mopar jeep
replacement would have been 38 bucks plus 10 to program it.  they have
another replacment  that wasnt mopar for 15 bucks plus 10 to program.  
have since put log chain on key to not lose. john jr

Any recommendation?
I hear Weber, Holley?
Thanks in advance for insight!

I got to thinking about this maybe being local to #2 so I decided to pull a
main bearing to see what it looked like:
Here you go:
http://members.bigvalley.net/wuji/jeep/mainbearing/main_2a.jpg

Help Changing break hose?
I cant get the Break hoses to break free from the line.  By this, The Lines
come form the Master Cylinder, and then the hose goes to the Caliper.  They
join at an inline connection, I cant get them apart.

Hey everyone,
I was driving my '89 YJ home last night (4.2), and WHAM! the old familiar
sound of a drive shaft ruthlessly slamming into a muffler. No wories, I
thought, just 4WD it the remaining 2  km's and deal with it the next day.

Check out this link.  These people seem to think they have found the Holy
Grail.  I just thought it may interesting conversation.  This is the same
site that talked about the Chevy "Hour Meter" by turning the ignition off
and holding the trip reset button.  Anyone have this kind of ...

Can I safely use Goodyear P225-75-R16 on my '97 Jeep Grand Cherokee? They
look little bigger than my original P225-70-R16?
Thank you, Victor

Tried to climb a snow bank last week and I got the
awful cluch burn smell.  I think the 4WD got bogged down
and I gassed it a bit to much so the clutch started
slipping....

Hey there!
   I'm about to get an alarm system installed in my new TJ and was
wondering if anybody out there had some advice or cautions to offer.  FYI:
my wrangler is an '04 5 speed with full doors and a soft top.

What fluid do you all suggest for a dana 300 (cj7)?  Also, is it necessary
to remove the skid plate to change the fluid?  Thanks guys.

I'm considering buying and installing a roll control device on my '00
TJ.  Would like to know of any experiences with this particular
accessory and as it will be wired into my custom electrical console I
would like to know if the actuator switch is just a ground.  Any help