I have an 04 GC 4.0L and am looking for some good bang for your buck
performance enhancements that will still make a good wife's grocery
shopping daily driver, but add some HP and mileage?  Anyone have some
experiances they can share?

I'm in the process of swapping in a T-176 into my CJ7 that had an
automatic tranny. After swapping in the clutch and brake pedal assembly,
I noticed there is a big difference between the hight of the clutch pedal
and the brake pedal. The brake pedal being significantly lower than ...

I have a '95 YJ 2.5L wither manual steering. I want to change it to
power steering.   My resaearch so far suggests that I need the following
parts:
Power Steering pump & resivior

I have a really bad tap, followed by my car running like poo.  I'm going to
crack open the engine because I need to change the valve gasket, and while
I'm at it, I'm going to check out my lifters and such.  What is the
adjustment procedure for putting the valves in?  I have an 85' 2 ...

Ok, I changed the engine mounts, tranny mount, two bushings were fine.  The
motor mounts and tranny mount looked old, but didn't look broken in any way.
So after changing these I still have shuttering when engaging the clutch to
start moving (Both forward and reverse).  It does it ...

Can anyone suggest a dealer that I can get the best discount on a new
Wrangler.  Geography is not an issue.
Thanks.
Bill

doug,
i want to build a laptop cradle that i can use both in my jeep and my rhino.
i remember you had one in your jeep on your home page but i can no longer
find your home page.  any help would be appreciated.

Edge auto Industries of Canada sells defective merchendise and will not
honer thier warentee.I  called and wrote them numberous times,I got
nothing but run around,then flat out lies.
If you run across an add or link of thiers,DO NOT BUY!!! There are

Can a starter solenoid such as one from a CJ be used for as a relay for
continuous duty of 30 amps for wiring off-road lights.

I have been trying to find a Khaki spare tire cover with the black Jeep
logo. I have tried several dealers but no one has one. Where can I buy
one? I am in Houston, TX.
Rick

I have a 2002 Wrangler Sahara (stock)and am interested in possibly
getting larger tires. Is it possible to get a 1' lift to make space
for them. or is there a simpler way of getting this done?

My Jeep has a cracked exhaust manifold and I have ordered a replacement
from 1A auto. I plan on replacing this myself. I'm no mechanic,
but I can turn a wrench. Is this a straight forward enough job that
I can do myself? Any tips or be aware of ? I should know?

Hey everyone,
My 2000 XJ has been feeling 'weird' lately when I turn.  It feels like it is
in 4wd.  The shifter is in 2wd position, the indicator is not on, but the
wheel is jerky when I make turns.  I have put it in and taken it out of 4hi

Any ideas about the cause and correction of a drivetrain slap when normally
re-engaging the clutch between gears. The u-joints are good.
I have about 1/3 rotation of slack or play that seems to be in the transfer
case or transmission. There seems to be little or no slack in the rear

I have a 35c axle shaft that needs replacing in my 96 GC.  It has the ABS
tone ring.  Two questions:  1) are the lenghts of the axle shafts the same
for all Dana 35c rear ends, such that I could use an axle out of a tj or
whatever so long it was a 35c axle?  2) Can the tone ring on ...