Hey, it just occured to me. I havent been here in quite a while and when I
do come, I browse through really fast so I miss stuff.
I was just wondering, how are you feeling? How is your recovery doing? I
hope you are doing much better. This summer will be a year right?

I am replacing the rear oil seals on my '85 Jeep CJ7. This job sucks
due to the 2 piece axle and rusted on hub, so I don't want to have to
do it again. When I put the axle back together, should I use gasket
sealant between shims, axle housing flange, outer oil seal, brake

I would appreciate opinions you all might have on my very strange oil
pressure problem with my TJ
97TJ
2.5L

This is in San Diego:
Anyone in San Diego see the less than flattering Marti Emerald report on JSA
automotive? It was on tonight. I met him once, the news spot really made him
out to be a crook. Loads of small claims against him and etc. He does Jeep

Where in the hell is this thing?  I have a '90 Wrangler 4 cyl. that
has a oil pressure gauge pegged out, even without the motor running.
I was going to buy a new oil sending unit, but I can't even find the
one that's on there.  I assumed it was next to the oil filter, but to

In December, when I get back, I'm building my Jeep.  I'm going to
33's, adding a lot of weight, and a stroker, so I'm going to replace
the braking system.  I have read that slotted rotors are bad when rock
crawling in case rocks get trapped and scratch them, but on the same

I bent the lower lip on mine and it leaked out a bunch of fluid.  Now I
can't find where to refill it.  I could have sworn I did this about 6
months ago right after I bought the Jeep...  I just can't seem to locate
the fill plug now.  Can someone tell me where it is?  Thanks!

Hello Group
A Friend who owns a 99TJ 4.0L
is complaining of the 4X4 lever rattling while driving
down a paved road. Stops rattling when pushing on it.

The shift stick on my YJ (AX-15 transmission) is very loose, and wobbles
around a lot.
I have removed the boot, and the stick, but am not sure what part I need
to replace to get it back to normal.  I though there would be a nylon

has anyone bought this stainless steel header, any good? piece of junk? get
what you pay for?
thanks
-Joe

Thinking of putting together a CO2 system for airing up my tires. I'm
finding some conflicting info though - for example, some people say
buy a regulator that they sell for beer taps, other say you need a
"high flow" regulator.

What's everyone's take on these oils? are they worth the 50% more? Do the
"conditioners" in them work?
Jason

Group,
This has probably been covered before, but what front alignment specs are
use on a 2000 XJ with a 3" lift?  Coils with 1.5" pucks (for the added
weight of a winch & bumper) are used in the front.

http://7slotgrille.com/multimedia/peteunf.html  5 meg video of pete in the
rock garden at uwharrie.

I was wondering if someone has a list of things to have checked for my
spring tuneup? YJ-93  Thank you very much.