OK, so I can choose which terminal is #1 on my distributor.  Just so I
understand things, doesn't the gear on the distributor shaft mesh with
a gear on the camshaft?  And doesn't the
flat-bladed-screwdriver-looking end on the distributor mesh with the

hey everyone,
   im finally going to break down and put some new rims and tires on a
credit card, before i do i just want to make sure im getting a good deal..
  i went to the local offroad shop and this is what he had for me:

i went to vip to get some rust preventor stuff and there was lke 4 different
kinds. i first asked them if they had por 15, since ive heard a lot about
that here but they didnt. im not doing anythign too major, just the floor
pans of my tj are pretty rusty. does anyone have a ...

I have a 1942 running Ford Jeep Willys
What I need is a kind of book where could look to restore this wonder
I´ll be glad to here from some body to help me about it.
thanks

Hi Deb I know you check this group so I'm saying hi and wondering if you
have a picture of your jeep online somewhere.

I'm in the market for a slightly used (or new) Sailcloth top. Looking for black
with tinted windows. Want to see if I can find one for a better deal before I
fork out $700 on a new one. Anyone know where to get a better deal on one
(new)?

I have a 1988 Jeep Wrangler and it appears that I have to change both from
hubs. I see that these hubs for this year jeep come from the factory
preassembled and with the seals in place. The are going to cost me $136.05
each. So there goes a bunch of money, but that is not my only ...

Well I am going to change my diff oil for the first time and while I was
buying brake pads and rotors and other stuff I asked the parts dude for the
gear oil I needed for my 97 TJ Dana 30 and 35c stock differentials.  He gave
me gear oil under the name "Parts Master SAE 80W-85W-90". ...

In a past interview posted at newsmax.com, 1st lady wannabe, Theresa Heinz
Kerry, said she regretted marrying an American, and was ashamed of her
choice of husbands, both of them. She plays the "I'm just a poor girl from
Africa," routine, and further goes on to badmouth "wealthy ...

Thanks to everyone for their help and advice. I have decided to go
with the Rubicon Express 2" budget boost. I still have a few
questions.
- I am also going to go with the GY Wrangler MTS 31x10.5 15's on my

I resealed the rear main on my '94 YJ yesterday and per the official shop
manual the edges of the rear bearing cap should be sealed with a small (3mm)
bead of Loctite 515. Unfortunately no one in town, including my local Jeep
dealer had any idea what that stuff was. Everyone who ...

"00 XJ with 50k, sanden compressor. According to pressure gauge I'm
seeing about 30psi from the low port. Thermometer in center vent reading
about 39f with 75f ambient after driving around, center vent about 55f
at idle.

My right front wheel shakes out of control sometimes when I hit a
small bump. It is only on the right front do I feel the tire shaking.
Any clue what this is and what the damage will be? (heading to the
autoparts store in 2 hours)

I took my 94XJ to a local Jeep hobbyist install/repair shop with some
blow-by in which I have, he explained that I need to flush my engine, but
googling around suggests that it may be my PCV valve (which is broken,
physically) but also when the guy stuck his finger into the filler ...

Just bought a 1998 TJ with new 31 inch Goodrich tires.  I think these larger
then normal tires are screwing with the gas mileage and the handling at hwy
speeds.  Since they are new I think I trade them for original tres.  Do you
folks think that will make a difference.