I went out to Calico this Saturday and had an absalute blast!!! the only
problem is I did break the rear axle on the driverside it seems like.
Anyway, My question for the group is, I want to upgrade the axle shafts in
my Dana 44.  I am running 427 gears right now.  What can I do?  I ...

I was curious if there are any new updates planned to the models that
will come out later this year/early next year? I found some posts
related to IFS and the 3.8 V6 from the libby, but curious if these
have been confirmed?

Who among us (besides me) is heading for Moab, UT for the Easter Jeep Safari
next week?

I am contemplating swapping stock for either a Gibson cat back or a TFX on
my TJ.  I have heard good and bad regarding Flowmaster and Borla...any
opinions would be a preciated.  My goals are to increase performance (mpg/hp
although it will only do it slightly), sound good, and be ...

Decided to pull off the roll bar before I get my CJ in the garage to start
my tub swap.  WIth 8' ceilings and my CJ sprung over with 35's I figured I
better take it off outside.  So the first bolt I try to remove (t-40 torx)
on my tub swap, and it breaks the torx bit right in two ...

sorry i didnt take them hope you enjoy them
http://cherokee.groundclearance.com:81/albums/album09/P2240006.sized.jpg
http://cherokee.groundclearance.com:81/albums/album09/P2240007.sized.jpg
http://cherokee.groundclearance.com:81/albums/album09/P2240009.sized.jpg

Odd, the one cylinder I expected to be low wasn't
1 160
2 160
3 160

Some may remember that I recently posted a question regarding getting my
new weber carb to idle at a decent speed, without overturning the idle
speed screw.  I got a couple of new idle jets -- bigger -- to play with
also.  Anyway, checked vacuum and it is holding strong, 20 psi at ...

My cat converter is rattlin' something fierce at around 1200-1500 RPM.  Any fix
for this or am I looking at a new one?  If so, what should I get (factory or
aftermarket) and what do they cost roughly?
-jeff

Come on you old hot rodders.....
Anybody have any good info on Dixco hood mount tachs?
I'm interested in a replacement for one that looks identical to this one
(minus the ford logo)

I have been lucky so far by not having a flat on a trail ride but it is
going to happen at some point.  I have my Hi-Jack, lug wrench and spare tire
onboard and ready for the occasion.  Should I be carrying anything else to
change a tire?  Are any of the Hi-Jack accessories a must ...

see rubicon pete and ron byram at tellico.  49 minutes of video, 180 megs.
http://7slotgrille.com/multimedia/rptellico.html

Can someone tell me the width of the ford 9 inch and the suitability for a
Wrangler TJ?
Tks
Bill

I have a set of Rubicon Express Spring Over Springs.  One set is five leaf
and the other is six.  This is an ongoing debate; Which goes on the front
and which go on the rear?  Pro Comp and Skyjacker have the exact opposite
opinions on this topic.