Hey Guys,
 I'm also looking for some new wheels for my Scrambler.  I have aluminum
American Racing's on now, with 33 X 12.50's.  My Jeep is Black, with silver
lettering and tonneau cover.  The AR's are silver (an older style, i'm not sure

Okay I have the 4 spacers, I go to drop the T case buy removing the 4
bolts,, and two of the bolts are installed from the top down!
How do I get them out, do I have to pull carpet up or what, lol, ??
help..

The AC compressor wouldn't come on in my 97 Cherokee Sport. I added 2
cans of r134a with sealant. The compressor came on and the AC got very
cold, but I could smell this smell like alcohol inside the car. The
next day I tried the AC again, and the compressor wouldn't start. I

What is a good online source for Cheorkee body parts?
Jason

First, I have a concealed handgun permit, so I can legally have a handgun in,
for instance, a center console.  To anyone reading this thread, check your
local laws as they vary wildly from state to state.
I keep a loaded handgun in my TJ.  At present I use my factory locking center

I have finally acquired my first Jeep. It is a '96 Grand Cherokee  Orvis
edition with 95K miles, v8, leather, ...and a few problems.
1st, What is an 'Orvis' edition?
2nd.   I need to replace at least one tire. It now has 3 good shape

Hey newsgroup, you're all invited to check out our latest Jeeping Adventure:
Jerry & Tim do Moab 2004!
My buddy Tim and I are lucky to live within a few hours of Moab. Having
worked & lived back East for 15 years, I know what it's like wishing you

Hi all.  I have a '76 CJ-5 with the 304 engine.  I recently did quite a bit
of work to it, replacing lifters, intake, carb, and ignition.  Now it
starts right up and runs GREAT.  Idles great, good power, etc, etc...  BUT
my oil gauge is reading pretty low pressure and it worries ...

Top Fuel Dragster:
- Dragsters reach over 300 miles per hour before you have completed reading
this sentence.
- One Top Fuel dragster 500 cubic inch Hemi engine makes more horsepower than

I have a 97 Cherokee Sport that I woul like to install cruise control.
Does anybody have any experince in this sort of thing? Could I install
the factory one from used parts?

All,
What is involved in installing the Mopar trailer light wiring kit?  The
dealer quoted me $38 for the part and $120 for labor (1.5 hours).
Doesn't the thing just plug into a socket on the wiring harness somewhere?

My evaporator cracked (little) on '97 Jeep Grand Cherokee. Last summer I
used A/C stop leak for Red Tek and one time refill. Works fine for full
summer. Is it OK to use same thing this summer. It won't clog anything in
A/C system, or it is time to put new evaporator ($$$).

How are the Liberty's holding up compared to the 4.0 Cherokees? It's time
for me to trade but have some doubts as to the ability of the new V6 to hold
up as well as it's predecessor. Any Thoughts? RM~

    i have a 2001 grand cherokee 4.0l with 33,000 kms. recently i have been
experiencing a misfire at idle and in cruise speed. i have replaced the
spark plugs as well as the wires , the injectors were cleaned prior to this
and after. id appreciate any assistance with this as this ...

I've got a 258 engine on a '89 YJ. Unless I'm wrong about this, the original
valve cover was made of plastic but the one I have is made of aluminium (did
I spell that right).
If I'm correct in my assumptions above, will a regular NAPA gasket work with