| Thread | Last Post | Replies |
|
| Weird power steering problem | 27 May 2004 20:36 GMT | 5 |
Hey all, I have a 93 4.0 Wrangler that has had a power steering problem for a while. Sometimes it would work and then out of the blue it stops working. Its never actually stopped working while I'm driving, only
|
| Cherokee Speaker System | 27 May 2004 19:12 GMT | 1 |
once again...99' cherokee sport. seems like the rear speakers are wired to not produce a high bass output. I have 240 w pioneers in the front and back with the stock deck, and the front cranks out bass to the point of it sounding like subs, but the rear speakers seem like all ...
|
| Video of Tough Grand Cherokee | 27 May 2004 18:24 GMT | 1 |
http://www.ifilm.com/ifilmdetail/204155 Another Jeep saves the day! -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
|
| PING >>>> Mike R | 27 May 2004 18:20 GMT | 6 |
Ok, so my admittedly bad driveshaft angles have killed my rear pinion bearings, from the other post I gather that it may be a safe bet that the t-case seals are damaged as well? Also, (my apologies for being so damn thick) I really really don't get how/where any fluid my leave
|
| Synthetic Oil in New Jeep? | 27 May 2004 17:44 GMT | 7 |
I have a new 04 Grand Cherokee V8 and when I took it back to the dealer for an oil change I asked if they would put in Synthetic Oil and was told that Jeep does not recommend it. I thought Synthetic Oil adheres better to metal and is much better then the regular oil. My question ...
|
| Steering Issues | 27 May 2004 17:27 GMT | 2 |
Hey all...I have an Automatic 4.0 99' Cherokee Sport. First issue...when Part Time 4x4 is on and I turn the wheel to the left or right and accelerate, the wheel shakes back and forth and it feels like the wheels are slipping.
|
| Help! Paint related. | 27 May 2004 14:34 GMT | 4 |
My 97 TJ has the upgraded (?) wheels, clearcoated , The clearcoat didn't last long here on the coast. I drive on the beach every day and it's hard on equiptment. A few issues back. in either JP or 4Wheel magazine there was an article concerning repainting with what looked like an ...
|
| Seat lifts for TJs | 27 May 2004 06:41 GMT | 2 |
I remember a post(s) back a while. Are there any kits to lift the front seats of my 99 TJ? Feel like I'm "sunk" in the tub" Hahahaha Thanks in advance
|
| Please help: Weird tail-light problem... | 27 May 2004 04:56 GMT | 6 |
I have a 1988 Jeep Wrangler, I love it to death. But it's got this very annoying (and illegal) problem. The right tail-light is out. Now, the bulb works. I know this because the same bulb is used for the turn-signal, breaks, and hazards. If all those lights work, then why doesn't ...
|
| I think a lawnmower is better than a jeep | 27 May 2004 04:11 GMT | 11 |
Yes, I think lawnmowers will always beet jeeps, because jeeps are useless vehicles.
|
| Electric Fan Motor | 27 May 2004 02:57 GMT | 10 |
1999 Grand Cherokee w/ 4.0L. The electric cooling fan was going through a slow death (decreasing RPM's) so I recently replaced. The new fan worked fine for several days then it ran constantly after the engine was shut off. For several days I just unplugged the fan so it would
|
| Just had my engine dyno'd and air fuel ratio checked | 27 May 2004 02:38 GMT | 31 |
4.2 block / 4.0 Head. Results: 124.9 Horsepower. I should have about 160, yes? Air/Fuel ratio came back a tad lean if anything. Engine has about 60 miles on it.
|
| CJ7 Windshield - Lower Bracket bolts | 27 May 2004 00:53 GMT | 5 |
I am removing the windshield and hinges. Working on the lower hinges has been a problem. I have heated the bolts and got them to turn. On the driver side I had to drill them out, and discovered that they had nuts on the end of the bolts.
|
| This had to hurt | 27 May 2004 00:06 GMT | 8 |
Why you need a rollcage. It's only 891K, non-graphic, but scary. http://www.g503.com/videos/jeep.mpg
|
| CJ7: Voltage regulator | 26 May 2004 23:08 GMT | 1 |
I'm just reading the new book "Jeep CJ Rebuilders Manual" by Moses Ludel and there is a chapter covering Electrical and Ignition system upgrades. The main topic is installing a MSD 6 ignition unit, and he writes: "Like other electronic devices, the MSD/6 requires clean, reliable ...
|