I am seeing cracks at or near the welds where the hoops meet the doors on my
'97 TJ, moss green.  Any solution other than full body shop work-up?  I could
see that getting real spendy real fast.
-jeff

    Still trying to work out the exact route to 33" tires, is it
possible to install the Full Traction 4" lift kit with the supplied
transfer case drop hardware and run the existing slip yoke and
driveshaft as an interim before going to a SYE and CV driveshaft.

OK, armchair Jeep mechanic warriors.
'76 CJ-7.
It has sat mostly in one place for the last month.
Last time I parked it, it had a full tank of gas.

Why would you want to stretch a wheelbase on a CJ7?
Wheelbase stretched to 101" (7" over stock)
http://www.jeepsunlimited.com/forums/showthread.php?s=&threadid=531499
Bill

Ok, maybe it wasn't a disaster, but it is frustrating no less.  I get my new
Dynomax "super turbo" (how the heck can a muffler be "super" anything, let
alone "turbo".. sheesh.. marketing.. ANYHOW) and proceed to rip out my old
stock exhaust.  At this point I'm realizing what a pain ...

anyone know of any good spots around minneapolis/st. paul or in close
to MN in wisconsin?  They have stickers you can get at DMV here that
allow you to offroad in designated areas, but I can't get any
information on any of the areas.

Hi folks.  My husband has the above vehicle and is having some problems.
The car has 135,000 miles.
Over the years he's had issues of stalling or not starting.  In March we
were in Colorado, driving down a gravel road at about 11,000 feet and it

i've got a 94 yj 4.0 high output, and noticed a crack in the header where
the 2 pipes join to go towards header.  who has suggestions on the best
performance, longest lasting, most durable, and reasonable cost (under
$150)

I was wondering what the red line / max RPM for this motor is.  My friend
and I tried to look it up in a couple of books but the closest thing we got
was 3200 rpms.
Thanks again

I'm interested in putting a sub in my 1997 Cherokee Sport. Does
anybody make a box for the indent in the right rear, or does anybody
know of a news group that I could post this request at?

 Any info where to buy them?

OK my wife and I are heading to Baltimore MD from Maine this weekend to pick
up a 99 Jeep Sahara and my/our only problem is this..... it comes with a
soft AND a hard top... the hard top is on the jeep naturally but the owner
doesn't think that there will be enough room to fit anyone ...

I'm having trouble with my carburetor and know NOTHING about setting
up a carb so I was hoping to get some input from y'all on this.  I
have a '76 CJ5 with 304 V8 in it.  I put on an edelbrock performer
intake manifold and a Holley 670 Truck Avenger carb.  I had problems

So I've had my 94 YJ 4cyl 5spd for a few weeks now, and I've noticed
some quirkiness in the clutch and gear shifting.  1st gear sometimes
takes a lot of force to engage, I get bad grinding sometimes when
shifting into reverse, and I've noticed that 2nd gear and sometimes

The brake lights used to work - I checked them before I bought it 2-3
weeks ago.  Don't ask how I found out they *weren't* working....
The point of this is to moan about what an inconvenient place the
brake light switch is located.  After taking out the driver seat,