I just contracted to buy a `96 Cherokee, auto, 4.0 High Output.  Now that
I've gone and put a deposit on it, is there anything about that particular
model year that I should have known about?

Read the story and then click the link of the camera at the bottom to
view the movie.
This is real and from a red light camera.
http://www.snopes.com/photos/accident/carcrash01.asp

I like to convert my 2000 Cherokee to disk brakes in the rear. Anyone have
any experience with any of the bolt on kits made for this?

Located in Mesa, AZ
As shown, Warn Overdrive and matching Dana 18 transfer case. Condition
unknown, appears complete but I am not for sure. Sold as-is. Very much
prefer a local pickup. $450 plus $25 to crate and buyer pays shipping

Woke up with a pinched nerve in my neck yesterday... Literaly, could not
move without severe pain.  Much better today, but since my seats are already
very ragged I think I'd like to upgrade to a more back friendly seat.
Something that can also handle the offroading jolts.  Any ...

How do I go about figuring out the gears
in my 91 YJ.
I jacked up the driver side rear and rotated it
while counting revolutions of the drive axle....

I'm redoing the fuel lines on my 85 CJ7 rebuild.
I have a 20 gallon plastic gas tank and it has 2 nipples on the top
that are vented directly to the charcoal canister.  The manual says
there should be a liquid check valve and a rollover check valve

Greetings.  I have installed (well, almost) a pair of signal mirrors on my
1997 Cherokee Sport.  The hardware is all attached and everything, but the
wiring is giving me some fits.  I bought a multimeter from eBay and waited
patiently for its arrival.  Now that I have it, I can't ...

   I totally overhauled the brakes on my jeep, new rotors, drums,
pads, shoes and all, and THEN the brakes started pulsing horribly.
Here is the problem:
   The rims on this Jeep contact the drums on the outer rim, when it

i took the rubicon into what i consider high altitude (10,979 feet) today and
was really pleased with its performance all the way around (handling, pulling
grades, etc.).  i know there are higher places, but after spending over 30
years at 85 feet elevation this was a pretty big ...

This is a local guy that has been building a Liberty.  Not sure on all of
the specs, but I think these are Dana 60's and a 4 link suspension.  He is
still working on getting it built tough enough, but you can see this guy is
going to ok with a little body damage.

Ok, so now I've gone & done it, I bought a Ford SuperDuty 6.0L turbo diesel
pickup to pull my Jeep on a trailer. Now, it's necessary to get the bleedin'
trailer. Can anyone offer up some specs I should be looking for?
I assume I'll need 5000 lb capacity, at least 16' length, double ...

Here's the deal:
I installed a 1.25" Body Lift and 1" Motor Mount Lift on Saturday
Night.
While driving it home, it didn't feel as "peppy" as usual. (I have

Greetings.  I have installed (well, almost) a pair of signal mirrors on my
1997 Cherokee Sport.  The hardware is all attached and everything, but the
wiring is giving me some fits.  I bought a multimeter from eBay and waited
patiently for its arrival.  Now that I have it, I can't ...

Do fan clutch's go bad? And how can you check to see if it has or not?