I have a problem with my 87 Wrangler.
I was out doing a little wheeling on Saturday when I got back on the
road and shifted back to 2 high  the front axel would not disengage. I
was 120 miles from home . So I had to drive it home with the T-case in 2

I bought new tires for the Wrangler, but due to an unexpected addition
of a new vehicle the Wrangler will be going into the barn for 2-3
years.  Meanwile the Liberty needs new tires, and since the ones on
the Wrangler are just going to dry rot I was thinking of swapping.

Can someone send me a picture of where the oil pressure sending unit is
located on a 304? I just bought a new unit today and the only place I can
see it might fit is right behind the oil filter. The problem is 1) the
filter is in the way 2) the threaded hole in my block is a ...

I went to www.alldata.com to see if there was any information on a recall
for the a/c evaporator in a 2000 Jeep Wrangler. It listed several service
bulletins, including one for an a/c leak and one for an "Evaporative
System - Leak & DTC Diagnostics" but no recall info. Would this ...

I just bought a 1950 willy's pickup and need to get parts . If any one
can help it would be great.  
 thanks Mike
 47 Willys

http://wm.prmediacast-na-regional.speedera.net/wm.prmediacast-na-regional/DCStud
io/Oct04/Jeep_Climb.wmv

I have a TJ w/ 4" pro comp lift, a SYE kit, and a cv driveshaft.
I didn't have the sye kit & cv driveshaft put on until almost a month
after the lift was put on, so I was driving along with a bad vibration
at 35 and 50 mph, for almost a month.  I had the gears done, along with

Hey all I have a 97 sahara with a dana 35c open rear.  Im upgrading my
33s to 35s within the next year.  Before i add the 35s im gonna regear
to 4.56 but im unsure on what to do with my dana 35.  My plans are
either to regear to 4.56 and add super 35 to the rear with a detroit

Ok, two problems today:
1. I had my wife pick me up a 33 tooth speedometer gear -- as that's what a
website (linked to by multiple other sites) said I needed. Finally get it
installed and working, and it's 10% off. Not much of a problem at low

Windshields are not bad at all....but thanks to one of my fine fellow citizens,
(loser theif), I know have to replace the backseat passenger door window on my
'96 Jeep Grand Cherokee Loredo.   Safelite $250, 89glass $375!   (on site
repair).

On my 91 YJ the ignition switch got jacked up while my mechanic was trying to
fix the turn signal/wiper/high beam switch.  Well the new switch has a few
problems.  Firstly, Is the heater blower supposed to be on when the key is in
the Acc. position.?  Secondly, when the switch is in ...

I have a question reguarding headers for my jeep.  I have an 83 CJ7
with 258 engine.  So far all I have done is put in a K&N air filter in
it.  I would like to increase the horse power and was thinking of
adding some headers.  i was told headers will not make much of a

maybe someone can clear this up. what is the difference in full and
half doors that fit on 1987-1995 wranglers and the ones that fit on
1997-2004 model wranglers. why aren't they interchangabe? now a
similar question about hardtops, will a 1997-1002 hardtop fit on a

Hi folks, thanks for all of the tips over the years. I'd like to get a
few opinions on a situation with a 96 GC Orvis. It has 90,000 miles on
it and I've heard that my father took it down a large hill with rocks
in the trunk which caused symptoms of the whole car shaking going

Where can i pick up a reasonably priced spray gun with compressor to do the
durabak job? I see the gun at harbor freight, but whats a decent compressor
to use? I see one at sears for about 50 bucks...any ideas?