I just bought my daughters 2001 Cherokee Laredo. So far I love it. Its much
different than my Honda Accord!!! I would love to hear do's and don't. I
always change the oil and take good care of my cars...
But are there any issues with Jeeps....Like Honda's you change the timing

i just couldnt hold out any longer and placed my order for an '05 rubicon
today --> http://7slotgrille.com/forum/topic.asp?TOPIC_ID=552
i do hate the wait, but the end result is oh so sweet.

I'm considering buying my daughter a jeep (Wrangler) to use at college
so she will have something that goes in the snow.
Unfortunately, I have no experience or knowledge about the different
models, engine sizes, what to look out for, etc.

Off Topic. Bourbon Street, New Orleans Mardi Gras.
http://www.experienceneworleans.com/livecams_bourbonvieux.html

Got all the parts for the lift today, except the rear springs! Can I go
ahead and install the rear shocks anyway? The lift is only a 2" on my 89 XJ.
Would I be correct in assuming these new shocks are 2" longer? Will
installing them before the lift springs (I drive 40 miles daily) ...

I posted a while back about this and didn't get a single response so I'm
really just posting this as a heads up.
I purchased Bestop soft upper doors for my 98TJ about a month ago based
on their claim "fits factory soft top". Well, they don't fit well at

well the nephew went and bought a 2000 cherokee sport. of course had to
install a new stereo so he sparked something down below when he was
working on it and low and behold, his wipers dont work anymore. checked
all the fuses under the hood and under the glove box but all good. ...

Hi Gang:
Anyone have any ideas on a cheap online source for a Crank Position Sensor
for an 89 Cherokee LTD (Inline 6)?  Thanks for any advice.
I'm also trying to find an online source for dash lamps (bulbs). (anyone

Time to mount the body. I'm looking at a 2" body lift to clear the
clocked Dana 300 and NV4500 tranny. What kind of issues am I looking at
in a body lift on a CJ-7?

I know that real beadlocks are not legal on the street (at least in OR, I dont know
about WA or elsewhere), however, with all the new "street locks" out there, has
anyone had any problem with the cops over them?
In your opinions, what are the pro's and con's to running beadlocks for ...

I'm replacing the dist. in my YJ, 4 cyl. Anything I should know beforehand?
Any nasty tricks?? I removed the old one, and my new one wil be here
tomorrow morning.
Thanks

All,
I'm getting quite a bit of noise when the clutch is depressed on my '82
Scrambler with a 258, a T-5, and manual clutch.  This is before and after I
replaced the clutch throwout (release) bearing.  While paging through the

Just want to get the word out -
A white hard top from a 1976 CJ7 Jeep was stolen on approximately 4 Feb 2005.
If you are in the Northeast Ohio/Western Pennsylvania region and know anyone who
deals in Jeep or car parts, be on the lookout :)

Hi;
I own a 98TJ,but my question is not about my jeep.
I am looking for **part numbers** for
1. water temperature sending unit.

Hello Professors,
I want to inspect my motor mounts and transmission mounts on my 97 TJ.
To be honest I am not exactly sure where they are located or how many
of either.  I have given the area a blast at the quarter car wash but