Does the 1999 2,5ltr petrol Chreokee have both Part Time and Full Time 4
Wheel Drive?
thanks....ttfn.....Al

Hi, I'm very new to Jeeps but I want to own one, I have a few questions
though. I was at the Jeep wrangler website and saw that some of the models
had cloth for the side window and frame, can these cloth sides be folded
down? Can the models with the metal frame and glass window ...

My wife's 5.9 ZJ power steering pump exploded yesterday leaving the
serpentine belt somewhere behind us on the expressway and coating the engine
bay with power steering fluid. Does anybody know if it is possible to swap
the pump out of my '02 TJ 4.0 and put it in the ZJ? The ZJ is ...

Just got my jeep back from the shop after the water pump went.  Now it is
running hot.  Will go up to just below red line, then drop back down to
normal running temp.  checked the fluid in the rad and it is up to the top,
but the overflow bottle was real low.  topped that up and ...

Does anyone know of a header manufacturer that makes a dual exhaust manifold
for the 4.0 liter Jeep 6 cylinder?  This would allow a true dual exhaust
system.
I recall that this used to be custom-done on in-line motors years ago with

I have the 83 CJ7 torn apart, and am getting it ready to paint.  My hinges
are looking a little rough, if I could find some in better shape (or new) I
would like to put them on in stead.  Anyone have some in good shape taking
up valuable storage space?  Black would be my first ...

'82 CJ-8, 258, T-5.  Other than taking it off and measuring it, is there
any way to know if it has a 10.5 or 11 inch clutch?  When looking at the
catalogs to order a kit, I see an 11 inch for '80-86, a 10.5 for '80-81
and another 10.5 for '82-86.  I don't know which to pick and ...

I have a '80 CJ5, with a 258. Long ago I put in a Borg-Warner temp
gauge which has performed fine.
I took it to get it smogged a couple weeks ago, and suddenly the gauge
doesn't work. OK, could be coincidence, but I figure someone knocked a

My 2" for the 89 XJ should be here any day. It's got rear add-a-leafs, hydro
shocks all the way around, front sway bar bushings, steering stabilizer,
front coil spacers, sway bar disconnects, and a couple other little things.
Is it safe to lift the rear one day, install the sway bar ...

I just got a tow vehicle which is only rated to tow 4800 lbs....  so it
can tow my CJ,  but not the CJ + trailer.
Is there anything special I need to know before flat towing?  I'm
guessing I should put the transfer case and transmission in neutral,

All,
I have to replace the clutch housing on my '82 Scrambler with a 258 and T5
transmission (don't ask - stupidity on my part).  I've got a few questions.
First, in the clutch removal section of the factory manual, it says to

I am the proud owner of a 1997 Jeep Cherokee Sport 4 wheel drive. I am
intent on doing a transmission filter and fluid change myself but have
hit a bump in the road. The tranny is an AW-4 (automatic 4-speed). While
I was under the car, I noticed a metal pipe connected to the side ...

Anybody know whats the story on jeepsunlimited.com. They seem to have
been down for the last three days .
Thanks

HELP!  NEW JEEP TO ME.  HEADLIGHTS WORKED...BUT NOT NOW...RUNNING AND
SIGNALS ARE OK.  dOES ANYONE KNOW WHERE THE FUSES ARE LOCATED FOR THE
HEADLIGHTS?  ALSO WHERE CAN I FIND AN OWNER'S MANUAL
THANKS....DOUG

I replaced my slave about 10 days ago and yesterday I noticed I was
losing pedal on the drive home, when I got home I found that the res.
was empty. I assumed that maybe I had a leak or maybe the slave was
leaking but upon further inspection I found fluid on the firewall....I