I've got an '88 Cherokee (Pioneer), with 4.0L and Auto Trans.  Lately its
getting very picky about when it wishes to start.  On random occassions it
cranks, but sounds like its not getting fuel (even though the fuel rail is
pressurized).  It seems to do this when the engine is ...

Bill do you have a links on Harley carbs? I remember a bike or two from your
previous posts, and was wondering if you had any links on rebuilding 883
carbs from 81-87.

My front end just started vibrating at 80+ km/h.  It is a manual 5-speed
with the straight six.  I took it in and got the tires balanced and the
front end checked and nothing was spotted.  Two days later I put it into
four wheel and I heard a dull thumping noise from the front ...

I have a 94 YJ with a very sloppy steering wheel. So my question is this: is there a bushing or bearing at the top of the shaft or column that can be easily replaced? I have tried simply tightening the nut on the shaft but it is definately tight. Any help is appreciated. Thanks

The heater fan control knob on the dash now only operates on "4"
(highest speed).  I know it's simple enough to pull the dash bezel off
and replace the control, but before I order a new part, my question is
this:  Before I go to the dealer or boneyard to find a new switch,

I have one of these on my CJ-5 and need to take it off
in order to fix the turn signals. Does anyone have a hint
how to do so? I can get the wheel off, :^) but I'm stuck
removing the security hub. I emailed Grant but haven't heard

92 XJ Laredo 4.0 auto 4WD . The driver side u-joint is loose. Shall I
replace the whole axle shaft or just the u-joint. Should I replace both side
at the same time?
thank you for any commments

howdy men, my sons cherokee started shaking and the engine light came
on. he had it in once for this and they said it was a fuel pump problem
i think but apparently it didn't get fixed. it is the six cylinder with
36,300miles. thanks john jr    

Im about to purchase an auto-meter,2-5/8 water temp gauge,
to go with my machanical oil gauge,
,
i was wondering if the elecrical is better or worse in its readings

91 wrangler 4.0L - anyone have a troubleshooting diagram ? I'm not sure
if this year is all mechanical driven or electronic sensored... anyone
know what year they went electronic? I'm assuming there is a sender
unit on the transmission and a reciever unit going to the speedometer

I have an '02 sahara with the stock 15x8 rims & was wondering if I could
put some 32x11.50's on them without any rubbing.
thanx......

I think I asked this before a long time ago...
But I need a new clutch for a 258 that had a T150 tranny,  but replaced
it with a ford 2wd T18.  I need to replace the clutch because the one I
bought 2 years ago is the wrong pressure plate driven disk combination.

What are good spark plugs for  a '93 ZJ with the 5.2 L V-8?  I just
checked with the Jeep dealer and they want $102 plus tax to change 8
spark plugs!  That's ridiculous.  The Mopar's are probably pretty
expensive, but I haven't changed any plugs for so many years I don't

Don't play on railroad tracks!
http://www.quadscentral.com/videos/trainhitsjeep.WMV

Anyone replaced rusted out rocker panels?
Any tips or where to buy both sides?
Replaced floor on pass side now for this.....
Thanks