I'm having trouble removing the flasher unit for my directional signal
on my 1990 Jeep Wrangler (by flasher I mean the cylindrical shaped
switch mounted just above the fuse box) I assume it just pulls straight
up, but it doesn't seem to want to budge and I'm afraid of breaking it.

What am I in for here? I have a '80 CJ5. I discovered last week that I
can start it without a key, even when it's in the locked position. Is
this something I'm going to get so pissed off at trying to replace it
that I'm better off just doling it out, or is it relatively straight

Ok, I've had my '88 Jeep Cherokee Pioneer for 5 years now and I have always
been curious about this thing on the ceiling, just above where the
windshield meets the cab-ceiling in the center. There is nothing about it in
the manual, It is about 1" tall and 1-1/2 to 2-1/2 inches ...

I'm really not worried about changing the speedo gear to compensate for
the larger tires, however, will the offset be a count against me for a
vehicle state inspection (MD)?
thanks

"Standing ovations have become far too commonplace. What we need are
ovations where the audience members all punch and kick one another." -
George Carlin
http://www.fallingskyhazard.com/catalog.htm

Does anyone run or have you run in the past, a header on your 4 cylinder? I have a YJ with the infamous cracked exhaust manifold and I am debating between welding the crack to save some cash or just replacing the whole damned thing with one of those nice stainless Banks headers. ...

Wahts a good oil pressure for a 4lt wrangler............
mine sites at 3 ....driving just a bit above
but sometimes when idle drops below 3 ....2ish
is this normal as i dont remember it doing this before

Does anyone know what the crash impact rating is on the OEM bumper for a
99ish Wrangler?
I.E> How much weight it can withstand without bending/cracking/breaking in a
front end crash

New Jeep Commander (ick!)
http://new-york-auto-show.autoblog.com/entry/1234000963037258/
Jeep GC SRT-8 (kinda cool, but probably worthless off-road)
http://new-york-auto-show.autoblog.com/entry/1234000863037255/

I replaced the speed sensor, I no longer get a code 15 for No
speed/distance sensor signal, however, I still don't have a output to
my speedometer and I still stall when I'm in neutral while slowing
down.

Could someone point me to a link or part number,
for the older style (with straps) bikini top,
for my 90YJ,
i DO have the channel on my windshild as i have a softtop,

A friend of mine has a 1980 Dodge Ramcharger with a bad transmission. It has
a D60 rear, and a D44 front. Limited-slip in the rear, manual hubs up front.
Is it reasonable to have these shortened to be installed on my 89 Cherokee
after my next lift? (probably 6+" in the works).

I have a 1976 CJ7 Levi edition Jeep with the 304 V8 engine.  It is in
need of a overhall. The body needs to be totally sand blasted and
repainted and I want to replace the engine. I am thinking of putting a
remanufactured one in.  The one I have uses 1 qt. every other tank

I posted this on another site without success. Maybe somebody here?
I'm writing for a friend to hopefully, get some ideas about how to go about
finding a solution to his problem.
93 Jeep, not sure of the model (Wagoneer? Town and Country?) 2wd, inline 6,

A friend has a TJ. It's a 97 4.0 with 124,000 miles.
At high speeds if you give it alot of gas it won't shake but when you let
off the gas it will start to shake via front end.
Around 35 to 40 it will shake under normal/light acceleration.