i was driving my 2000 jgc tonight, noticed the oil pressue gauge was pegging
80, normally is around 60 at highway speeds.  Slowing down helped, but even
at idle it never got below 50 or so.  After i parked, i noticed a slight
odor of rubber burning coming from under the hood.  The ...

I want to get rid of my caution stickers on the visors of my '04 wrangler.
I'm afraid that if I start peelin', there will be left a gooey mess with
intermittent sticker parts left over.  Have you removed yours?  What is the
best way to do so?

My check engine light just came on today. I have recently changed the
plugs, and I know my cat. converter is on it's last legs. Could the cat
be causing this light to come on?
Thanks!

I am renting a Jeep Wrangler for 10 days in Anguilla soon. They are
pretty lax with the rental rules there. They actually allow 4x4 use with
the rental Jeep. about half their raods are dirt.
I never owned a Wrangler. I have a 94' Cherokee Sport which has seen

I'm close to installing a 1" daystar body lift on my 91 yj
I have a RE 2.5 Ed lift and T case drop on the rig
Has anyone installed a 1" body lift with a t-case drop?
If so did you have any shifting issues? I really do not want to cut my

'99 XJ with power windows.  The regulator on the driver side was
replaced long ago under warranty.  It had the plastic bracket holding
the glass and was replaced with a metal one.  Passenger side also broke
- but just after warranty.

Is this a trail rated Liberty?
http://68.49.40.190/videos/7.wmv
good fun.

I have possible access to some aluminum rims that have the clearcoat
peeling.  Does anyone know of a way to clean them up so they look really
great?

in line 6 2wd. 205k miles.automatic, its green.
this has been the best purchase of my life (save for the mail-order bride)
but I've got a couple of
"dumb guy" questions.

Hi Everyone,
I replaced the steering column in my CJ with a factory tilt column but the
shaft bearing just below the steering wheel is toast. ANy ideas where to
get a replacement? I was thinking of trying to match up a sealed bearing as

Does anyone have a step by step for the removal/install of a water pump for
a 90 4.0L????  What about for the head gasket????
Thanks,
Dave.

I bought a new Rubicon, fresh off the lot in July of last year (10 months
ago).  Today I was at a car wash, power washing and a half-dollar sized chip
of paint on the mud flare(?) on the passenger side popped off!!  Other
smaller paint chip problems have occurred over the past ...

Ok.  My '04 Liberty came with keyless entry and two remotes. They are not
identical as one does not have the button to release the back glass.
One does not work. I follow the procedure in the owners manual.   Now, the
one I programmed works, but the other one stops.

Just added a second jeep to the drive, a 1993 grand (ZJ??), anyways the only
fault it has is that the oil level sending unit is wonkie,  anyone know
where I can get info on this thing?  wiring diagram? or ???    .
Thankies

Hey all,
you are all so great, I have a question.
I'm putting a used Lund sunvisor on, and I have a general idea as to the
screws and caps. But, what about a sealant around the holes? There must be