Finnally got myself a YJ! It is an 89 with three tops (hard with full doors,
soft with half doors, and bikini). 2.5L with 93000 on the odometer. Sahara
brown. Anyway, I cant decide between getting a new RE 4" spring kit, RE
spring-over, or the Rocky-Road-Outfitters spring over kit.

I have a 93 TJ 4.0L, 2.5" body lift, 1" shackle lift, and ax15 trans.
Original rims were banged  up and looked like crap, got a very good
deal on used 15x8 rims.
---Q1 size: For stock gears (I'm assuming 3.11?)should I go for 31 x

http://www.leclone.com/jeep.html
Details in the link with pictures

I am in the process of gathering info and parts for a SOA on my 95 yj
6-cyl (I have put it off to long). I am planning on a danna 44 front
axle from a 76-77 bronco and a ford 8.8 from a newer (90's)ford
explorer with a limited slip diff.

I've got the FSM for the truck, which gives the spec's on how much to torque
it, but can someone point out where it is I'm supposed to tighten it, and
can I use something besides the "Adjustment Gauge (J-34651)" to adjust it?
Right now, the brake alone isn't enough to keep my ...

Subject says it all....  the wifeys XJ is making the familiar ujoint noise,
either of you guys have a recommended place?  I'm pricing it out now and
hoping to get the work done by late this week early next week.
Why does my XJ always breakdown when I go looking at a 2nd one???

Ok the short of it... how does one go about removing the front hubs?  I
have a noisy bearing on the drivers side (eliminated the ujoint), I was
interested to know of any tricks, do's and don;ts .
Thanks

We have a 2001 Jeep Grand Cherokee... Laredo -
Since the Jeep has 43k miles on it,
any specific maint that really "should" be done now ?
Have done the usual oil changes, and I think the 15k service,

1986 CJ7 4 cylinder      (150K miles but engine was rebuilt at 90K)   I was
hoping it might be the fan......took it off. Still clattering . Maybe the
alternator or power steering pump.......took them off. Still clattering
OK it must be the timing chain. Opened it up and the chain ...

When I do the  3 time key turn thing.. I get these 2 codes.  One is  power
loss (I'm paraphrasing) like when you disconnect the battery.  But My clock,
etc have no memory loss.  The second code, 21 is for a bad O2 sensor which I
change about 6 months ago.

Ok Everyone, wish me luck, I'm heading to the garage to install my new
Rubicon lift......I may be callin for help!!!  :)

I've read about all the problems with Jeep brake rotors,
and yup - we've been there at around 30k miles.
Now it's 15k miles more & starting with the shaking....
The rotors were turned the last time I was in at 30k,

evening everyone, anybody have a clue as to the cost of  whats called
the track bar for my 98 cherokee sport. making alittle clunking noise
when i turn a certain way. looks almost like a ball joint type thing on
the one end. thanks john jr

89 YJ rubicon lift.  I have two wedge spacers for between the axle and
springs.  Which way does the fat end go???  Front or rear of front axle?
thanks
Robb

Anyone got any tips on improving gas mileage in a Wrangler Sport?
--Brian