| Thread | Last Post | Replies |
|
| What & Where is the CTO Valve? | 19 Oct 2005 03:50 GMT | 5 |
Just working on my vaccume lines.
|
| YJ aftermarket cruise control | 19 Oct 2005 02:42 GMT | 1 |
Looking for info on aftermarket cruise control for 93 YJ. thanks
|
| Fram C3P depth filter 2 microns filtration | 19 Oct 2005 01:08 GMT | 5 |
If anyone wants to know: According to Fram oil tech people the Fram C3P filters particles down to 2 microns in size. It is called a depth filter.
|
| How does TJ Cruise Control behave? | 18 Oct 2005 20:57 GMT | 47 |
Can anyone comment on how cruise control behaves in a manual transmission Jeep TJ? Specifically, what happens if you are on a incline which requires down shifting. Does the motor stall out or does cruise control disengage automatically?
|
| bright backup lights for '96 Grand | 18 Oct 2005 18:38 GMT | 5 |
I do a lot of backing up into narrow driveways and lanes at night and I'm not happy with the light output from the (stock) backup lights installed on my '96 GC. Does anyone have any suggetions on how to get incresed output from my
|
| Can I Junk My Ignition Module? | 18 Oct 2005 15:16 GMT | 1 |
I recenty added a DUI distributor set-up, does this mean the igniton module can now be removed with no consequences. Can I just unplug & unbolt? Thanks!
|
| Charcoal Canister Off-Now What | 18 Oct 2005 15:09 GMT | 9 |
i am slowly bringing my 1986 Jeep CJ7 up to snuff. Today's project besides taking care of my kids is service of the canister. I got it off and there was filter at the botton looked like wall insulation VERY dirty & dry...it's gone now!
|
| 1997 WRANGLER SE WON'T START | 18 Oct 2005 13:18 GMT | 12 |
after 6 days of rain, my 97 tj se won't start. there's a fast clicking, so i thought it might be the battery. i put a vom on it and it read 12v, but i threw a 10a 5 hr charge on it anyway. the inside lights got brighter, but it still won't turn, just clicking. i tried until it
|
| Wrangler short shaft kit | 18 Oct 2005 02:48 GMT | 1 |
Is it easier to install a short shaft transfer case kit with the transfer case installed or pulled out? 91 YJ auto
|
| Headlight Adjustment Clips - 1984 Jeep Grand Wagoneer | 18 Oct 2005 02:25 GMT | 3 |
The headlamp assembly for the 84GW uses a spring on the lower left corner as you look at it. On the top and the right edges there are adjustment screws to counteract the pull of the spring, allowing you to point the light where you want it relative to the the housing. The
|
| 89 cherokee 4wd engage/disengage problem | 17 Oct 2005 22:30 GMT | 7 |
okay I am stuck. I have been told that there is supposed to be a vacuum line running to the front axle differential to engage the front axle to 4wd. I am as green as they come when it comes to this vehicle. I cannot find a vacuum line running to the unit. If there is a vacuum ...
|
| exhaust manifold for 258? | 17 Oct 2005 20:24 GMT | 5 |
Anybody have an exhaust manifold lying around they dont need for a 258? Looking for options besides a replacement to my rusted out header. Thanks
|
| 93 Grand Cherokee heat & defroster | 17 Oct 2005 19:30 GMT | 4 |
In my Grand Cherokee, the fan only blows out the dash vents on every setting. Under the dash, I can see the motor is working, but the link that it drives keeps popping out. How can I get into the heater box to see what the problem might be? Any ideas would be helpful.
|
| Transmission fluid for TJ? | 17 Oct 2005 01:59 GMT | 21 |
I have a 5 speed, 98 and am taking it into a mechanic tomorrow. I need to know what I can pick up at the Auto Zone. Also the manual says to drain/refill transfer case. Something I have not done. What will work for that?
|
| CJ7 starter / solenoid | 17 Oct 2005 01:51 GMT | 15 |
Hey y'all; I have a '79 CJ7 that I'm slowly replacing, piece by piece. I drove to my Dad's today, and my Jeep wouldn't start. I ended up popping the clutch to get it to run, but couldn't take it to work since I didn't
|