I have a 2004 jeep wrangler unlimited (LJ) and I am in the process of
installing an OME 2" HD lift and a Currie 1" body lift with a 1" motor
mount lift.  I have some new AR 16x8 rims and need to select tires now.
I use this as my daily commuter and head off road about twice a month ...

i have a 1990 Jeep Wrangler YJ with 95k miles and lately it has been
randomly turning off on me while im driving in town. it doesn't do it on
the highway. is it the fuel filter? i just replaced the battery, the
pre-heated caruberetor hose, and the distributor cap, so i dont think ...

I am looking to purchase an entry level easy to use GPS System, we usually
go to Connecticut every weekend and are looking for alternate ways when
traffic rears its ugly head.
I have a 2001 Grand Cherokee Laredo, and have narrowed the list to Magellan

The driver's side outside door handle broke and I had the local delaer
fix it.  HOWEVER, when they put the panel back on the panel closest to
the dash seems about 1/4" to 1/2" higher than the back of the panel.
Is there an adjustment or did some grease monkey not get all the clips

My 94 YJ 2.5, 5spd is leaking clutch fluid and would like to draw upon the
experience here. The 94 YJ has a sealed system and requires the replacement
of the clutch master/slave cylinder and hydraulic throw out bearing which is
all in one according to Chilton's. Since it is a ...

Well I finally did it!  I am now the proud owner of a 93 Wrangler, 6cyl,
auto (I know, I know, but the wife like it) It only has 130K on it. It has
both the hard and soft tops.
So what should I look for or do first.

OK, I'm a little bored so I updated my CJ rebuild page today.
If you are interested, check it out.
http://www.geocities.com/co_big_cheese/rebuild.html

just got a 97 wrangler -
I want to intall a dome light strapped on the roll bar - which way is
the best? how should I connect it? should I use a switch?
obviously do not know much, so I am in desperate need for advice!!

My wife's Wrangler's soft top is coming apart at the seams and we're
considering going to a hard top.  Is is hard to convert?  Looking for
opinions on any options... getting the old one re-sewn, buying a new
soft top, buying a hard top, etc.

The oil pressure gauge recently went to 80 one morning and has consistently stayed there.  I had my oil changed to see if this would help but hasn't.  The vehicle is running fine, but the pressure is at 80???  This has never happened, has always been around 40-50, then shot up to ...

    Jason Baldwin, a Baja 1000 racer:
http://www.baldwinracing.net/Photo_Album/pics/JasonFrt2.jpg lost his
life in a pirate plane:
http://www.signonsandiego.com/news/metro/20051121-9999-1m21baldwin.html

Got an electrical prob thats puzzling me plenty. Hit a bump in my cherokee
and the heater blower stopped working.
checked the fuzes in the engine bay, all ok. started pulling things apart to
get to blower switch (dont ask!) but discovered fuze box inside cabin.

I cannot comment on the running cooler claim but the one that wasn't
mentioned is that Nitrogen is 'dry' and won't promote rusting of the wheel
and freezing in the valve.  'They" say the water initially in the wheel will
migrate out over time as it is vaporized by road heat.

Over the last few days I noticed my temp rising from its normal of 210 to
about 222 (first tick mark to right) usually when idling at a stop.
Yesterday the check gauge lights fires up and my temp reads 247 (3rd tick
mark to the right).  I immediately pull over and before I can kill ...

I'm troubleshooting a lukewarm heater problem and a couple questions
have arisen which I haven't found answers to.
First - the vacuum valves and heater slider flap (thing) under the dash
all seem to be working correctly, just to make sure I also verified