Going to be installing a 1 inch transfer case drop and was wondering if
those that have done this had any problems with shift linkage?  Will I
have to do anything with the transmission or tcase linkage for this
much drop?

'Four-Wheeler's Bible' states that a 31x10.50 tire can be used on a Wrangler
YJ without any vehicle lift needed. My question then is what wheels would be
needed for this size tire. The local Jeep dealer tells me they could be
mounted on stock wheels but it would not be the right ...

I'm remembring a road test of a Mopar Parts high performance intake manifold
for the 5.9 Magnum engine but can't seem to recall where it was.
The test installed the intake in a GC 5.9 and became a tire smoker as a
result.

does anyone know if the 93 xj has limited slip on it?

Hey, does anyone know if I need a special tool to remove the plug wires
from my I4 2.4 03 jeep wrangler.  It has the coils in the wires, and
don't want to screw them up and have to replace them.  Thanks ~D

Application charts state that they are not suitable for installation on
axles with a vaccum axle disconnect.  I've heard that they can with
certain modifications.  Something about drilling and installing some
sort of pin somewhere.  Has anyone accomplished this mod and/or in some

For Sale
1979 Jeep CJ7
Frame off restoration completed last year
360 CU engine, w/ new Holly carb

2 years 3 months and some odd weeks, I still havent given up on it.
This jeep is like a marraige. I cant afford to leave it.
First, how do these u bolts go into the hood? they just dont make
sense.

hello everyone, is' t me the jeepney driver. my 93 xj has 210k + on it and
i'm using mobil 5w-30 synthetic oil in it. i was just wondering if the high
mile or 4x4 oil is better for it. i also notice that other people on this
site talks alot about 10w-30 oil. well i live in san diego ...

I noticed a strange rattle under the hood today, the PCV was vibrating
a million miles an hour. It still runs good but sounds a bit different
(other than the rattle). I just replace the PCV a week or so ago. Any
ideas?

Any thoughts on the TrailMaster lift kits. I am thinking of going with one
for my 93 rebuild.
Thanks.

I've been battling an oil leak on the front of my 360 for a couple of
weeks. It has been there months, maybe years, but has recently gotten
worse. I couldn't tell exactly where it was coming from, but it was up
front, near the oil pump, and was dripping off the oil pan lip onto the

I would like to do a flush and fill of the power steering system.
I was thinking of draining the old, then using ATF fluid to do a flush (so
fill it and then drive around the farm for 1/2 hr) then draining and putting
in the right powersteering fluid in.

Just in case anyone is interested, I found out today that 91 XJ that was
stolen and crashed has finally been laid to rest in a car crusher. It will
be re-incarnated into some sort of Toyota.
R.I.P, fair XJ.

I have a 96 Jeep Grd Cherokee Laredo, 4.0 6, recently when I go to start it
inthe mornings on my to work, it won't start, or maitain an idle unless I
keep my foot on the gas.  I have to keep my foot on the gas pedal, and brake
at the same time to put it in gear, or else it shuts off ...