Rilly, a JIP.
http://www.microcarmuseum.com/tour/kapi.html

Okay, here's the deal:
Talked to a parts guy this afternoon.  He is smart.  He told me that
assembly line streamlining from 2005 on mandated that the offensive
primary throttle return spring be eliminated.  Sort of.

anyone have the safari doors for a tj? I just aquired a set and put them on.
There seems to be a small round piece of rubber you put on the striker so
the door will latch.. It is a little flimsy... the door has about 1/2 inch
play..it wont come open but when driving it vibrates a ...

Locker question. What brand of rear locker will work with both 33 inch an/or
35 inch tires?   97TJ, 4.0, 410 or 411 ratio (see my other question)?  I am
not running onboard air.  This is a daily driver.  Locker to go in the rear,
Ford 8.8 rear end.

I am looking for a '98 Jeep Grand Cherokee drivers door panel, light grey
with no cracks, Mine has developed many cracks and would like to get a new
one. Anyone know where I could possilby get a new one, or anyone that
doesn't have any cracks? Thanks!

I need to understand what option to go with. I am putting a Ford 8.8 rear
end on my 97TJ. A typical rear end ratio for the Ford is 410, while on a
Jeep it is 411.  Maybe I am off base here, if so, just let me know.  Should
I go with a 410 or a 411 ratio?    I am currently running ...

Well, I must have been under a rock or in lala land to miss this.  I was
listening to Goss' Garage today and April 1st 2006 all gasoline will be E-10
(10% ethanol) which replaces the current MTBE additive.  Pat discussed the
new stuff at length and basically stated it will be ...

I have a 95 Jeep Cherokee (Commander) with the Rease hitch. Considering using
it to haul a John Deere tractor (1700lbs) with a front end loader(200lbs) and
a backhoe attachment (500lbs). If I can use this vehicle to tow with (has
trany cooler), what type of utility trailer do I need ...

When I was a kid growing up in the '60s I remember a Stainless Steel
Jeep Wagoneer visiting the Butler (PA) Armco plant. I recall it as some
sort of promotional thing between Kaiser Jeep and Armco and it coincided
with the opening of Butler Armco's plant #2, and was somehow tied ...

I own a 1991 Cherokee Laredo with the 4.0L engine.  I have been
fighting a hard start problem, which I posted earlier to the group and
got alot of good feedback.  I put an Actron fuel pressure gauge on the
vehicle and here are the results.  After I turn the key on, the

i have a cj-7 1979 with a straight 6 in it that seized up due to a
severe oil leak puncture in oil case; engine seized up. i came across a
buddy who put a 2 yr old crate small block 350 into a truck and stop
using it. Is giving it to me i got it to run almost perfect and just

4.0 I6
Doing my usual maintenance and picked up on a rhythmic tick
from the front/passenger side of the engine?  Looks like the
harmonic balancer might not be running true.. little wobbly

Can't sleep - tossed and turned, dreamed Jeep all night,
I Looked at Jeeps, shopped for Jeeps, drove Jeeps, bought three or four in
my dreams...
argggggghhhhhhhhhh

can one of you Jeep gurus help me out? i have been given a 1987 Jeep
Wrangler (4.2L 6cyl) and have been having trouble getting it to start
reliably.
when the vehicle is completely cold it starts right up no problem, it

when I drive through a rut or a pot hole with the front passenger wheel
I hear sort of a "clunk".  Yesterday I pushed (with my foot) the top of
the wheel inside and heard a pop (just bearly heard it.
So I am wondering, is there a bearing there that's worn out what does