Hello, All I am doing a conversion from a 4 cylinder to a V8 AMC 304
engine i need to find the motor mounts for my project.  I have been
unsuccessful tring to located these parts that i need.  if any of you
have an idea or a web site where i can find what i am looking for it

I know someone selling an '88 Cherokee XJ Limited, I suggested parting it
out. He is willing if there is enough interest. The vehicle is located in
the London Ontario area. I would think that pick up or shipping wouldn't be
a problem.

I wonder how this will affect Jeep?
http://quote.bloomberg.com/apps/news?pid=10000103&sid=a6I_XTCVHya0&refer=news_index

98 CHEROKEE ROUGH RUNNING
98 xj, 6 cyl.  Runs rough after starting, when engine warm runs smooth.
No check engine light. Have done maintenance in following order
1. Took off fuel rail; full of crap, install fuel rail and do injection

I am down to 1 key for my GC and want to get a replacement. I have
found a source online for the blank key with the chip and it can
apparently be programmed without any equipment. Problem is you need
both original keys to do this.  Do I have any other option short of

I'm about to drain and refill the front and rear differentials on my '98 GC
5.9 and am open to recommendations.
Fuels economy is a factor in my choice.  I do not tow with the vehicle and
most of my driving is interstate at 70+ mph.

I've got a neighbor who has a Rubi. 2005 I think. He's getting ready to lift
it and put 35" tires on without a gear change. (not a choice I'd make but
non-the less). He's wondering what he can do to recalibrate the Speedo
without going to the stealership. I'd know what to do if ...

i have a dana 44 from an XJ i'm swapping into my TJ that has a d35.
the build sheet i got says i have ABS.  will the brakes from my d35
work with the d44?

When I put my 2000 JGC V-8 into full time 4WD, it works fine.  But
when I go back to 2WD and I am cornering tight at slow speed, it's
like someone put the brakes on.  Never noticed this until a Jeep
dealer did a complete brake job last summer.  They replaced rotors and

Whats the stock shock length (extended and compressed) for the front a
TJ? And what kind of mounts do they use?

I have a 98 wrangler and need to remove the front seats and backets to
install new carpet.  I got the front bolts out but cannot figure out
how to get the back ones out.  The seat doesnt tilt up anymore and i
have no clue how to get to the back bolts?  anyone knwo anythign about

Is it just me, or has jeepsunlimited.com been down for the past 2-3 days?
Art

i have a '98 jeep grand cherokee laredo that started making a grinding
sound when the car is started and then continues once in drive up until
around 30mph or so and then quiets down.  It seems to be in the front
from what i can tell.  Mysteriously, this was not a problem at all 3

Last year I took out my Air Conditioning in my jeep, but never got around to
removing the compressor.  I replaced the belt with a shorter one to bypass
it totally.  Now I'm gonna try out installing on-board air with it but since
then the intake and outtake ports in the compressor ...

How easy/difficult is it to wire up the two bar electrics on my Cherokee
Jeep, 1997?
And does anyone have a preferred type of tow bar to fit?
Thnaks a lot in advance.