| Thread | Last Post | Replies |
|
| Tire Pressure: How low can I go? | 02 Mar 2006 16:19 GMT | 21 |
2000 Jeep Wrangler, 33 inch MT Baja Claws on 15X8 rims (no beadlocks). I am planning to attend a Jeep Jamboree. How low can I safely air down to without the likelyhood of running a tire off a rim?
|
| 96 Jeep Cherokee 4.0L trouble code 43 | 02 Mar 2006 14:01 GMT | 2 |
After driving about an hour and a half on the freeway, we stopped at a gas station. When we left, it started fine. We went another few miles (city driving) and stopped for 15 minutes to half an hour. When we started the jeep, it ran rough (but a consistent rough). We pulled
|
| Concord Police Department Officer Ron Turner is a fucken dirty black pig cop | 02 Mar 2006 05:03 GMT | 3 |
Concord Police Department Officer Ron Turner is a fucken dirty black pig cop First the cop called for chp portable scale to get the wt of my truck he could not get one then he had me
|
| 99 Cherokee Oil Pressure too high-help | 02 Mar 2006 04:01 GMT | 2 |
I have a 1999 Jeep Cherokee with 150,000 miles on it. Runs good and still has lots of life in it, I hope. A couple of days ago the oil pressure began to register about 80lbs compared to what has been about 40lbs normally. Now today the check engine light went on. Jeep still
|
| anybody built theier own CJ frame? | 02 Mar 2006 02:50 GMT | 30 |
Anybody done it? is it worht it? Seems it would be better than 30+ yr old OEM ones, and maybe cheaper than $$$ replacements.
|
| Torque/HP curves | 02 Mar 2006 02:11 GMT | 16 |
Ok, here's the deal. I drive everything using the tachometer. Yep, even my 2.5L TJ. I determine shift points according to torque rating for the engine. The problem is, I'd like to get my hands on a Torque vs RPM curve, - or
|
| Hard tops | 01 Mar 2006 21:30 GMT | 7 |
I have a 97 TJ and i was looking into buy a hard top do i have to buy full doors or will half doors with soft upper work?
|
| Jeep Tomb Raider Groups/Clubs? | 01 Mar 2006 15:56 GMT | 3 |
Does anyone know of a Jeep Tomb Raider Group? With it being a limited production vehicle I was wondering if someone had formed a support group for parts and decals.
|
| Locking diff question | 01 Mar 2006 15:48 GMT | 8 |
Is it difficult to install a locking differential on a Jeep Grand Cherokee? What is involved in this? thanks Fred
|
| Cherokee starting problems | 01 Mar 2006 04:15 GMT | 2 |
98 Cherokee 93,000 miles. Wont start in park, ( Nothing ) but will in neutral ????? Expensive fix ??? or backyard ?? Thanks, Mark
|
| How Do I change my upper radiator hose on a 2000 jeep 4.0L | 01 Mar 2006 02:41 GMT | 8 |
I have a 2000 jeep cherokee 4.0L V6 I have a big leak in my upper radiator hose. When looking at the clamps they don't look easy to remove. I have the part and am ready to replace it. Does anyone have any tips on removing the clamps and installing the new hose?
|
| Dana 30 spindle question | 01 Mar 2006 02:40 GMT | 5 |
May be a stupid question for most, but haveing never worked on a front end of a vehicle, question is, is there a spindle on each side of an 81 CJ7 dana 30?
|
| cb question | 01 Mar 2006 02:39 GMT | 7 |
I recently picked up a used Midland hand-held cb at a garage sale. I have not talked on the radio, but it seems to pick up cb traffic on the highway about a mile from my house just fine with the short antenna mounted to the radio. I understand the capabilities of this radio are
|
| TJ D35 LSD | 01 Mar 2006 01:04 GMT | 2 |
I was talking to a buddy last night, telling him my plans for my front locker and he mentioned a way that would make my LSD in the rear stay locked...he says he knows a couple people who have done this... Just looking for peoples thoughts on this...
|