I have noticed a noise in my YJ that I thougth was the throw out bearing
as it goes away when the clutch is pressed(while sitting in the seat),
but by listening in the engine bay the squeak sounds like it is up front
around the water pump.  I have not had some one else press the ...

My son, a 3rd year student at Montana U.  has / had a '97 Cherokee
Country with all the bells and whistles. While trying to help someone
out of a ditch on an icy snowy road the jeep was smashed by a diesel
rig. As you may expect, it was totalled by the insurance company.

Have a strange tire wear problem on the wifey's 93 ZJ,  the inner edges
(almost inner 1/3rd) or the front tires are worn almost bare,  This suggests
a problem with the camber angle,  in reading about this I have found that
the camber on the ZJ is non-adjustable, any ideas what ...

I have a '96 GC Laredo 4wd with a 4.0 that has 164k on it. My question is,
are there any good websites showing how to replace the front wheel bearings?

I'm moving to Hopewell, VA in April. I'm going to buy another Jeep when I
get there, and I have spotted a nice 97 in Springfield near Arlington. Would
anyone be availible to go check it out for me?
Thanks,

All,
My tranny was rebuilt at a local transmission shop last month.  It's
shifting fine after rebuilt, but...a few days after the tranny was rebuilt,
I noticed tranny oil accumulation on the ground, rendering the Jeep

Hello all, my stepson had a fatal crash in his jeep on 2-25, we spent
alot of time together working on jeeps and cars and i will miss him
very much, if you have time please sign his guestbook on the page.
http://www.cardomain.com/ride/2143270

Will OEM Rocker Guards from a 2003 Rubicon fit on my '97 Wrangler
Sport?  ...and IF so, how do they mount?
-Pete

I saw a post asking which was better & have watched a guy get his H2
stuck in mud that I can drive my TJ through, which is close to the Rubi
with my upgrades. The H2 got pulled out by a 4 wheeler

Hi folks. We run a Mystery Car quiz and if you identify it, you get a
free ad at http://www.classiccarfair.com.
All listings get a free ad in Classic Driver magazine. Kiwis buy cars
from all round the world, so this is a great

I just installed a reman NP231 with the SYE.  Lo and behold the input and
output yolks of the T-case won't accept the stock U-joint straps and bolts.
The stock U-joint strap bolts are 3/16 and thread into the stock yolks.  The
new T-case yolks have 1/4" holes and are unthreaded.  ...

I installed a new battery in my '88 Wrangler but connected the wires
backwards.  Needless to say there were sparks, hissing and smoke coming
from either the bottom of the battery or below the battery.  The car
starts and runs but the radio does not work and the volt meter shows

98 zj, 6 cyl.  Runs rough after starting, when engine warm runs smooth.
No check engine light. Have done maintenance in following order
1. New plugs, new wires,new rotor,new cap
1a. Took off fuel rail; full of crap, install fuel rail and do injection

Hi Group - Has anyone had any experiences with Fastrac soft tops? I
have been "negotiating" with an ebay company that sells both Fastrac
and Bestop soft tops. The seller claims the Fastrac is a bit better
than the Supertop. He says the material (Haartz) is just a bit thicker.

Any of you CJ / audio experts have advice on installing a standard (radio,
CD) deck into that "way_to_small" access port in the CJ dashes ??? ..... my
1985 vintage radio / cassette deck finally packed it in ......... and in
trying to find something that installs into that port looks ...