Blingy-ness.
.
http://fresno.craigslist.org/car/133450657.html

OK, I'm now still shaking from out little trip up a mountain road to play in
the snow. We went up this seemingly harmless road I have been up several
times before. I noticed sliding in some places on the way up so I decided to
turn around (good thing I did when I did, 'cause it ...

all right, so here's the deal, i'v had the jeep for a year. rebuilt pretty
much new everything, including the engine. about four months ago the engine
started missing every once and a while. i figured out that there was a short
in the wires with the help from a budddy. what i did ...

Suddenly the driver door on my 96 XJ wouldn't open all the way.  It seems
that little part called a "door restrainer" was somehow jammed up.  I drove
out the pivot pin and now can at least get out of the vehicle.  Does anybody
know this thing works ?  Seems to slide in an out ...

I'm looking at probably getting a used (1997-2001) Jeep TJ this year and I'm
wondering what problems they're known for/things to look for when checking
out used ones.  Any years in that range to watch out for?
Thanks, lemme know.

I got the light on the dashboard while waiting in line to exit a large
parking lot. THe engine had been idling for about 5-7 minutes.  Code P0301
is a miss in cylinder 1,  however I never felt anything and the engine runs
ok to me.

I removed the doors (full steel) from my 1997 TJ Sport the other day.
I realized once the doors were off that the interior lights on my sound
bar and hard top remained ON, because of the buttons in the door
casings being left in the "open" position.  I ended up removing the

anyone know where the oil pressure sending unit is on my '03 2.4L TJ?
I've got a gauge problem, I've checked the plugs in the dash without any
sucess... I guess now I've got to find the sending unit. ~Dave

my '97 GC frequently has a brief hesitation after restarting a warm engine.
(I6.)  When cold, I never notice a hesitation at all.  I can drive until it
reaches operating temp.  If I restart the engine before it completely cools
down, it will hesitate some on the first ...

Just wanted to know what wax (if any) people use on their Jeep.
b

Bill, have some OT questions about San Diego. I'd like to email you
privately if that's okay.
Spdloader

Well here we go for about the 5th time.
93 Wrangler 4 cyl.
The slave cylinder goes "bad". Then the master cylinder "goes bad", and then "leaks internally". Then the
(goofy) plastic "line" between them goes bad.  (say wha? a plastic line with quick disconnects on a hydraulic

Does anyone have a button combo for turning off the base boost on the 6
CD changer.  I have already turned the base WAY down and it is still
muddy.

Where are the drain and fill plugs for trans and transfer case on CJ3B? Lots
of crud to knock off, I'd like to start in the right area.
Thanks.
yam

My 93 Cherokee has a bad resistor pack, where in the heck is it located
so I can replace it?
Jeremy