I put a brand new Wagner Slave Cylinder for my clutch.  Its internal.
And its leaking!!!
(3.0, v-6, supercab)
Any suggestions?  I pray its not defective.  Thats a lot of work :(

Where is the drier receiver located - and - it is hard to replace?
Apparently it's leaking.  My shop manual doesn't seem to call it out.
Thanks...
-curtis

this looks like a goat cum group. What the f.ck?   Does anybody do
anything with jeeps on here. If so who makes a conversion kit for a YJ.
I want to put a 350 Chevy in mine. Any kits available. Can I use my
transmission and transfer case is there any adapters.I've been away

As I mentioned earlier, Grace's WJ was involved in a rollover and it
looks like it's probably totalled... The engine was still running
after the rollover and my examination of the vehicle on Sunday made me
start to wonder if perhaps the engine could be salvaged... So, how

NASA has recently answered with a world press release to the prediction
of a mega tsunami, created by a possible impact of a fragment of the
comet SW-3 on MAY 25, 2006 in the Atlantic Ocean. This prediction,
based on a clear and precise psychic communication, was confirmed by

Looking for a way to install an AUX. Input into the Stock radio of a 97
TJ Wrangler. No, I don't want to use a FM modulator. (Cheesy, piece of
crap)
Can it be done?

I have what is I think a complete soft top frame (only) for a YJ Jeep. It
came off a 94 Wrangler.
No top curtains, or screws, just the frame and attaching brackets etc.
Would let it go for shipping or pickup cost to the right person.

I need a motor for my 1887 wrangler,,,anyone got one???

Has anyone tried to build up a 4 banger? Cam, headers, performance
parts. If so what kind of results did you have? I posted a while back
and a few thought I was a troll because of some language I used. When I
posted there were nothing but goat cum postings, I was wondering how

Warning!! Dangerous design flaw in the 2006 Jeep Wranglers!!
The 2006 six speed Jeep Wrangler has a very dangerous design flaw.  New for
the 2006 Jeep Wrangler is the six speed transmissions and what I have
recently learned the "hard way" is part of the redesign includes the ...

I have a 2000 jeep cherokee sport (not grand) and the trim seems to  be
fading pretty quickly.  I was just curious how hard it is to replace
the trim, if at all possible.  Also, I was curious about getting a
paint job and wonderd if its possible to replace the trim with the trim

Pulling the wire sends it full scale, otherwise it tends to twitch to
full scale erratically every now and then.  Wiring looks clean.  Engine
ground OK, but bypassed anyway as a test--no help.  Factory oil filter
replaced about a month ago, twitch didn't appear until about 2 days ...

Only 115K mi, regular synthetic oil changes, using up about a court
every 5K mi. With no leaks present, and quite sure it's not worn rings
... what else could cause oil consumtion if anything? It does set quite
a bit because we usually use it only for light hauling trailers ect.

I'm back in this group after about 4 years of being away.  I'll post a
proper (re)introduction soon.
I am originally from NJ, but I am spending the summer in Houston, TX.
I have a new '06 LJ and I am looking for any reccomendations for

This is on a '93 2.5L YJ.
I've just run across a wire near the MAP sensor that's been
disconnected, and it looks like it should be connected to something. It
was just tucked behind the valve cover, and I don't like the idea of